English Page 62
G. Display functions and programming possibilities
2. Programming 'signal lights'
LED 2 flashes.
• With button or the function
'signal lights' can be set (according
to table):
LED 1 flashes:
Permanent external signal light
LED 1 is on:
Flashing external signal light
• Save your setting with programming
button .
LED 3 flashes.
• Save your setting with programming
button .
The control unit changes automatically to
the programming menu 'external alarm
relay'.
GB
English Page 31
G. Display functions and programming possibilities
4. Programming 'RESET factory settings'
LED 8 is flashing and all others are on:
• Press button or to go to function
'reset'.
LED 1 is flashing quickly; function 'no
reset' is selected.
All programmed values remain unchanged.
LED 1 is on; function 'reset' is selected.
All programmed values are overwritten by
the values set from factory.
• Press button to confirm reset function.
When 'reset' has been selected, the control
unit carries out a new start, recognizable
by all LED's glowing for 2 sec.
The control unit is now in operation mode
(settings from factory), in case of power
failure all settings remain unchanged.
Advice:
All menus can be reset by a RESET function to the original
values set by factory. For this carry out the steps described in
the point 'Programming of the basic level'. After the remote
control has been saved, the control unit changes to the
programming menu 'RESET factory settings'.
