Handleiding M-System MSU-70 (pagina 4 van 20) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans)

522903

Verklein

Vergroot

Pagina terug

1/20

Pagina verder

FILTER ALARM: Displayed for 30" when the motor is off:

After 30h of operation the central segment lights up on the display; It indicates that the grease filters need to be cleaned.

After 120h of operation, the central segment flashes on the display; It indicates that the grease filters need to be cleaned

and the charcoal filters replaced.

After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the

key C during display of the filter alarm.

GAS SENSOR SENSITIVITY: The sensitivity of the sensor can be modified to suit your requirements. To modify the

sensitivity, the appliance must be in manual mode (i.e. the running speed and not the letter “A” must appear on the display);

If not, press the key E.

Modify the sensitivity by simultaneously pressing the keys D and E. The set sensitivity is indicated on the display. By

means of the buttons C(-) and D(+) the desired sensitivity is set Store the “new” sensitivity by pressing the key E.

ATTENTION: TO PREVENT DAMAGING THE SENSOR, DO NOT USE SILICONE PRODUCTS NEAR THE HOOD!

Controls shown in Fig. 10:

Key A : Turns the lights on/off.

Key B : Reduces and increases lighting intensità.

Key C : reduces the motor speed until reaching minimum. If pressed for about 2", it stops the motor and storse the

speed.

Key D : drives the motor (calling the last speed used) and increases the speed until reaching maximum.

L Display:

- signals the running speed.

- signals the filter alarm (with motor off) by displaying the central segment for 30".

- signals Timer activation with a flashing number.

Key E : activates the TIMER (when the motor is running), so that the hood stops automatically after 5'. Also Zero-sets

hour metering when the Filter Alarm is active (motor OFF).

FILTER ALARM: Displayed for 30" when the motor is off:

After 30h of operation, the central segment lights up on the display; It indicates that the grease filters need to be cleaned.

After 120h of operation, the central segment flashes on the display; It indicates that the grease filters need to be cleaned

and the charcoal filters replaced.

After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing

the key E during display of the filter alarm.

Grease filter: particular attention should be given to the anti-grease filter, which must be periodically cleaned when

the filter alarm appears. For any information about the Filter Alarm, please refer to the Commands paragraph.

Disassembly of the anti-grease filter: open the metal panel; push the retainer next to the handle inwards and pull the filter

downwards (Fig. 6).

Wash the filter with a neutral detergent.

Charcoal filter: if the machine is used in its filtering version, the charcoal filter must be periodically replaced when

the Filter Alarm appears. For information about the Filter Alarm please refer to the Commands paragraph. Disassembly

of the charcoal filter: open the metal panel; push the anti-grease filter retainer positioned next to the handle inwards, and

pull the anti-grease filter downwards (Fig. 6). Remove the charcoal filter from its relevant housing (Fig. 7).

Replacing the Halogen Bulbs: open the Halogen Bulb hatch by pushing it on one side (on the writing “PUSH”) and

then release (Fig. 11). Replace the bulbs with other bulbs of the same kind. ATTENTION: do not touch the bulb with your

bare hands.

This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic

Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative

consequences for the environment and human health, which could otherwise be caused by inappropriate waste

handling of this product. The symbol on the product indicates that this product may not be treated as household

waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and

electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste

disposal. For more detailed information about treatment, recovery and recycling of this product, please contact

your local city office, your household waste disposal service or the shop where you purchased the product.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

M-System MSU-70 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info