599356
12
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
Automatic
Sensitivity
17
=
KEEL OFFSET'
When the X-50 is in the automatic
mode,
the
sensitivity
of the
receiver
will
be
adjusted
above the minimum
required
to
pick up
the bottom
signal.
This enables the X-50 to
display
fish, structure,
and other small
targets
while in the automatic mode.
The
sensitivity
level can
be
changed
while the X-50 is in the automatic
mode. This
may
be
desirable if the level of
sensitivity
chosen
by
the X-50 is
not
enough
to show fish
or other small detail. If
desired,
any
amount of
sensitivity up
to the
maximum
may
be added or
any
amount of
sensitivity
down to the minimum
may
be subtracted from the current
setting.
To
adjust
the
sensitivity
while the X-50 is in
the automatic
mode,
simply press
either the
right
arrow
key>
to increase the
sensitivity
or the
left arrow
key
C to decrease it.
Holding
the
keys
down will
increase or
decrease the
sensitivity
faster. If
the value
goes
below the
minimum,
the
X-50's audible tone will "flutter". The same is true if
you try
to
go
above the
maximum level. As
you press
the arrow
key,
the
sensitivity
bar will
move
right
or
left,
according
to the amount of
sensitivity
chosen. The X-50 will
still
automatically adjust
the
sensitivity
as conditions
change,
but it will
always keep
the
amount
that
you
added or subtracted.
Most sailboats have a keel or a centerboard that
extends
many
feet
below the surface.
Many power
boats with
displacement
hulls also extend
many
feet below the surface of the water. The
digital
sonar
calculates the
bottom
depth
from the transducer's face. If the boat hull sticks below the
transducer,
then it can run
aground
when the
digital says
there is still
clearance. The X-50
provides
a keel offset
adjustment
that allows for the
depth
correction between the face
of the transducer and the bottom of the
hull. For
example,
if the bottom of the hull is
4
feet
deeper
than the trans-
ducer
location,
then the keel offset
on the X-50 can be
adjusted by press-
ing
17 from the menu selection. A new menu
will
appear:
KEEL
OFFSET IS
0.0 FT
ENTER
VALUE
IN TENTHS
THEN PRESS
Sensitivity—Manual
Operation
At
times,
it
may
be desirable to turn the
automatic functions off and
"fine tune" the X-50 to
the current conditions.
To
manually adjust
the
sensitivity, press
the
AUTO
key
once,
and auto
sensitivity
will be turned
off. The word AUTO at the
top
of
the
display
will
disappear, signifying
that the X-50 is in the
manual mode. The
sensitivity
can now be
adjusted
to
the desired level.
Figure
6 demonstrates a
graph
with too little
sensitivity,
while on the
right,
the
sensitivity
is
adjusted
properly;
a fish is now
visible,
the surface
clutter is more
pronounced,
and the bottom
signal
has widened.
When the horizontal bar reaches the far
right
hand side of the
screen,
the
sensitivity
level is at maximum. If
high
sensitivity settings
are
used,
a
second bottom echo
may appear.
This is normal and is caused
by
the
returning
signal reflecting
off the surface of the
water,
making
a second
trip
to the
bottom and back
again.
This is
called "second echo".
Occasionally,
when
high sensitivity
levels
are
used,
the
display
will
turn black.
This
happens
when there are
large
amounts of
surface
clutter,
thermoclines,
turbulent
water,
or
suspended particles
such as silt that
reflect the sonar
signal.
This does not
damage
the
unit
to
correct
it,
simply
turn down the
sensitMty
level.
To
return
to
the Automatic
mode,
press
the AUTO
key. Remember,
both automatic
sensitMty
control and auto
ranging
functions are
turned off
and on
by pressing
the AUTO
key.
UPPER
LIMIT FOR
NEGATIVE
OFFSET
LOWER
LIMIT FOR
POSITIVE
OFFSET
Since the hull in our
example
boat is 4 feet
lower than the
transducer,
we want to use a
negative
offset.
So,
while
the above menu is still on the
screen,
press
40. This is
actually
4.0 feet.
(If you just press 4,
the offset will
be .4 or four tenths of a
foot.)
The X-50 will now
display
the
depth
with a
four foot offset In other
words,
if the bottom is
fifty
feet from
the transducer
face,
with a four foot
negative
offset the X-50 will
display
the bottom
depth
as 46 feet
10
35
OR
PDF compression, OCR, web-optimization with CVISION's PdfCompressor
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Lowrance X-50 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Lowrance X-50 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,72 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info