ṇOld appliances are not worthless
rubbish. If they are disposed of in an
environment-friendly manner, valuable raw
materials can be recovered for use again.
Before you dispose of an old appliance,
make sure that it has been rendered
inoperative.
ṇYour new appliance was protected on
its way to you by the packaging. None of
the materials cause pollution to the environ-
ment and all can be recycled for use again.
Please help to protect the
environment and dispose of the packaging
in an environment-friendly manner.
You can obtain information about the best
method disposing of old appliances and
packaging from your dealer or local
municipal council.
ṇThe extractor hood can be used in
either exhaust-air or recirculating mode.
ṇAlways mount the extractor hood over
the centre of the hob.
ṇMinimum distance between electric hob
and bottom edge of extractor hood:
650 mm.
ṇInstallation of the extractor hood over a
solid-fuel burner which could constitute a
potential fire hazard (e.g. due to flying
sparks) is only permitted if the burner is
equipped with an enclosed, non-
removable cover and all country-specific
regulations are observed. This restriction
does not apply to gas cookers and gas
hobs.
ṇThe smaller the gap between extractor
hood and hob, the greater the likelihood
that rising steam will cause condensation to
form on the hood.
Additional information concerning gas
cookers:
ṇWhen installing gas hotplates, comply
with the relevant national statutory
regulations (e.g. in Germany: Technische
Regeln Gasinstallation TRGI).
ṇAlways comply with the currently valid
regulations and installation instructions sup-
plied by the gas appliance
manufacturer.
ṇOnly one side of the extractor hood may
be installed next to a high-sided unit or high
wall. Gap at least 50 mm.
ṇMinimum distance on gas hotplates
between the upper edge of the trivet
and lower edge of the extractor
hood: 650 mm, Fig. 1.
Installation Instructions: Important information
