735580
19
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
CO2 CONTROL - assembly and operating instructions
-19-
Alarm mode
Display
Measure
Pre-alarm
Intermittent
warning sound, red
warning light
flashes
Only enter the hazard area if a second person is
present adjacent to the hazard area. Open all doors
wide open!
1. Shut off all of the gas bottles.
2. Find and fix the leak and/or fault.
Call in the dispensing system service team if
necessary!
3. When the CO
2
content drops below the threshold
value, the alarm will reset automatically.
Fault
Continuous
warning sound,
yellow warning
light lit
These can include:
1. Cable break → The cable must be replaced
2. Device fault → Replace the component
3. Sensor unit fault → Replace the sensor unit
4. When replacing the sensor unit with no
re-initialisation → Initialise the system
5. Heavy smoke → Eliminate the cause; the system
will return to operating mode by itself
6. Severe sudden temperature variations → After a
short time, the system will return to normal
operating mode
Pressing the ALARM OFF key will restart the gas
detection system. If the system fault reoccurs, the
equipment will need to be repaired by the service
team.
7 Warranty
KUNDOxT provides a warranty for technical defects arising from the manufacture of the gas detection system within 24 months following the date of assembly
and commissioning.
The warranty covers the replacement or repair of the device free of charge. Additional costs incurred thereby are not covered.
The warranty is only valid when the card attached to the device is retained by the equipment operator, and the attached postcard has been completed by the
installation service and returned by the owner.
Please ensure that the serial number of the installed device is entered on the postcard.
KUNDOxT guarantees that the system requires no calibration and/or adjustments within 4 full years of operation. After 4 years of operation, a calibration will be
performed at our plant at cost (see 4. Maintenance).
8 Instructions for the prevention of hazards due to CO
2
gas
8.1 Code of conduct
1. Keep calm!
2. Acknowledge the audible alarm by pressing the "ALARM OFF" key on the warning unit, and another alarm off switch on the AM / AM PLUS version.
3. Determine which alarm is involved!
Main alarm: Continuous sound, Red light lit
Pre-alarm: Intermittent warning sound Red light flashes
Malfunction: Intermittent warning sound Yellow light flashes
For the CO2 CONTROL AM / AM PLUS versions in a CO
2
refrigeration equipment area, please observe the notes in the CO2 CONTROL AM / AM PLUS installation
sheet!
When the main alarm is triggered, no further access to the hazard area must be allowed!
To eliminate the hazard, an extraction unit (where available) must be used, or the local
fire brigade must be called.
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kundo xT CO2 Control bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kundo xT CO2 Control in de taal/talen: Engels als bijlage per email.

De handleiding is 1,55 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Kundo xT CO2 Control

Kundo xT CO2 Control Gebruiksaanwijzing en installatiehandleiding - Nederlands - 52 pagina's

Kundo xT CO2 Control Gebruiksaanwijzing en installatiehandleiding - Deutsch - 54 pagina's

Kundo xT CO2 Control Gebruiksaanwijzing en installatiehandleiding - Deutsch - 53 pagina's

Kundo xT CO2 Control Gebruiksaanwijzing en installatiehandleiding - Français - 20 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info