English
24
Au t o - O f f f u n c t i o n :
n
The heating plate will maintain the temperature in the jug for 2 hours after
which the machine shuts off automatically. This is for safety and
convenience. The auto-off time can be adjusted to 1, 2 or 3 hours.
See page 25 – Programming the unit.
n
For best results brew only as much coffee as you will drink within 30-60
minutes.
Pa u s e a n d S e r v e f e a t u r e :
n
You can remove the jug during the brew cycles to pour an early cup. Keep
in mind that this will change the taste you would normally get from a full
pot in a complete cycle.
Be sure to replace the jug quickly (less than 20 seconds) to avoid
overflow during the brew cycle.
For models with thermal pot : to ensure maximum heat retention, rinse
the thermal pot with hot water before use, and close the lid by turning
clockwise.
WARNING :
Hot water continues to drip in the filter holder (h) when
the jug (f) is removed. The overflow of coffee and hot
water could cause burns.
Do not exceed the maximum capacity of the water tank as
shown by the water level indicator (g).
Place the ground coffee into the paper filter or directly
into a permanent filter.
Note : Pay attention to max level indicated on permanent filter.
After use, discard the grounds, and rinse the filter holder under
running water.
CURRENT TIME; SETTING THE CLOCK : FIG. 16
n
When the machine is first plugged in, the clock blinks and ask you for
setting the clock.
n
Press the H and Min buttons to set the time. This will ensure the Auto-
On function activates at the proper time of day.
