Place the food in the beaker or in a container with sides high enough to avoid splashes.
In order to avoid splashes, do not fill the beaker (C1) with more than 800 ml/27 fl oz/
1.7 pts of ingredients.
1. Blender shaft: fig. 2 to 4
1.1 Assembly
n Insert the blender head (B2) or the crushed ice head (B3) (according to model) in the Cap (B4) Fig. 2.
n Screw the shaft (B1) onto the head making sure it is fitted properly and secure Fig. 3.
n Screw the shaft (B) onto the motor unit (A) making sure it is fitted properly and secure, then plug in the
appliance. Fig. 3 and 4.
1.2 Use
n Insert the shaft (B) in the beaker to mid-height Fig. 5, then select speed 1 using button A2 and press
the Start button (A3).
n Remove the cap (B4).
n Use the speed selector A2 to increase the speed progressively if necessary.
n Your appliance is equipped with a Turbo function that allows you to use it in full power mode by pressing
button A4. Fig. 6.
n In order to avoid splashes, insert the shaft (B) in your preparation before turning on the appliance
Fig. 7.
n If you mix hot ingredients directly in a cooking container, withdraw the container from the heat source
before doing so Fig. 8.
n The food must cover the lower part of the blender base to guarantee effective functioning.
WARNING: Do not turn on the appliance when the head is not immersed in food.
n Moving the shaft up and down inside the beaker will not make the hand blender more effective. Leave
it at mid-height and towards the centre of the container.
n In order to avoid splashes, stop pressing the Turbo speed button (A4) or Start/Stop button (A3) before
taking the hand blender shaft (B1) out of your preparation. Fig. 9.
Practical tips
For fruit-based preparations, remember to slice the fruits and remove any stones before putting
them in the mixing container.
Do not use the blender head (B2) for hard food products such as ice cubes, sugar, coffee beans,
grains, or chocolate.
If you wish to make crushed ice, use the crushed ice head (B3) (according to model).
1.3 Dismantling
n Disconnect the appliance.
n Unscrew the shaft and then the head using the cap (B4) Fig. 10.
2. Double whisk (D) (according to model): Fig. 11
2.1 Assembly
n Attach the double whisks (D2) to the whisk adaptor (D1).
n Place the whisk adaptor (D1) on the motor unit.
n Screw on completely Fig. 11.
English
19
