n Do not clip on the base (c5) from below (fig. 19).
n Position your mixer vertically then insert the adaptor (c1) into the corresponding holes turning slightly
until it locks completely (fig. 20).
n Place the 2.5 l container under the vegetable cutter to collect the food (fig. 21).
n Connect the appliance to the mains socket.
3.2 U
SE
n Place the food into the feeder tude, guiding them using the pusher (c3) (fig. 22).
n Set the button to maximum speed.
3.3 D
ISASSEMBLY
n Disconnect the appliance.
n To disassemble the drum holder (c2), press the button (c6) located at the front of the adaptor and
remove the feeder tube (fig. 23).
n Press the button (c7) at the rear to release the adaptor (c1) from the mixer (fig. 24).
n Remove the base (c5) by sliding it along the runners located at each side of the adaptor (c1) then the
drum holder (c2).
3.4 C
LEANING
n The drum holder (c2), drums (c8 c9 c10 c11 c12), drum locking ring (c4) and the pusher (c3) are dis-
hwasher safe.
n The mixer and the adaptor must be washed with a damp cloth.
n Note:
• Always use a plunger to guide the food into the feeder tube, never your fingers, nor a fork, spoon, knife
or any other object.
• When putting away your vegetable cutter, you can slide the base over the feeder tube. (fig. 25).
4 - BLENDER ATTACHMENT ACCESSORY: mix, emulsify (depending on model)
4.1 A
SSEMBLY
n To insert the blender attachment (d1), open the rear hatch (a5) (fig. 8).
n Insert the blender attachment and screw tightly (fig. 26).
n Connect the appliance.
4.2 U
SE
n Depending on the type of preparation, place the ingredients in the container provided (1 l bowl (e) or 2.5
l bowl (f) (depending on the model) or in a suitable container (bowl or beaker, preferably deep).
n The container must be filled to the maximum or two-thirds full to prevent spilling.
n Place the blender attachment (d1) into the preparation before turning on the appliance, this will prevent
splashes (fig. 27).
n When you blend directly in a container, remove the container from the heat source when mixing hot pre-
parations.
n The food must cover at least the lower part of the blender attachment to guarantee effective functioning.
n Turn on by pressing the button (a4) (fig. 28).
n Release the button (a4) before removing the blender attachment (d1) from the preparation to prevent
splashes.
n Practical advice:
• Never operate the blender attachment when empty.
• For fruit preparations, chop and deseed the fruit first.
• Do not use the blender attachment with hard food such as ice, sugar, coffee grains, cereals and chocolate.
4.3 D
ISASSEMBLY
n Disconnect the appliance.
n Unscrew the blender attachment (fig. 29).
English
20
