Handleiding Korg KingKorg (pagina 16 van 116) (Duits, Engels, Frans, Spaans)

707401

Verklein

Vergroot

Pagina terug

1/116

Pagina verder

KingKORG Owner’s manual

The three elements of sound: pitch, tone, and

volume

Sound has three basic elements: pitch, tone, and volume. Just like the

analog synthesizers of the past, the KingKORG analog modeling

synthesizer provides “oscillator,” “filter,” and “amp” (amplifier)

sections that control these three elements. Edit the oscillator settings

to change the pitch, the filter settings to change the tone, and the

amp settings to change the volume.

The KingKORG’s oscillators, filter, and amp

On the KingKORG, the oscillator settings are in the PROGRAM

“s05–s12: Pitch” pages and the PROGRAM “s13:OSC1–s27: OSC3)”

pages. Use the Pitch pages to specify the pitch of the basic

waveform, and use the OSCILLATOR pages to select the waveform.

The waveforms generated by these oscillators are mixed in the Mixer

page. The filter settings are in the PROGRAM “s31–38: Filter” pages.

On these pages, you can modify the tonal character by applying a

filter to the sound being generated by the oscillators. Finally, the

amp settings are in the PROGRAM “s39–42: Amp” pages, allowing

you to adjust the volume. By editing in these pages, you’ll create the

basic sound of the program.

EG, LFO, keyboard tracking, virtual patches, and

controllers

In addition to the oscillator, filter, and amp settings, the sound can

be affected by change over time, by its pitch range, or by

performance expressions. Such changes can be controlled by

modulators and controllers such as the EG (Envelope Generator),

LFO (Low Frequency Oscillator), keyboard tracking, virtual patches,

and the joystick. By using these modulators and controllers you can

apply complex changes to the sound.

Take a look at the illustration above. Observe the signal flow from

OSC  FILTER  AMP, and notice how the EGs and LFOs can

affect each section.

Timbres (TIMBRE A/B)

Each timbre consists of an oscillator, filter, amp, EG, LFO, virtual

patches, and equalizer. The KingKORG has two timbres, and you

can combine these two timbres to create a richer‐sounding program.

Oscillator (OSC1, OSC2, OSC3)

The oscillators give you a choice of 127 types of oscillator

algorithms, including the sawtooth wave and square wave typically

found on an analog synthesizer, as well as noise, PCM/DWGS, and

the waveform being input from the mic jack. You can also make the

waveform richer and thicker by applying the unison setting.

Mixer (MIXER)

This section adjusts the volume levels of oscillator 1 (OSC1),

oscillator 2 (OSC2), and oscillator 3 (OSC3), and outputs the

combined signal to the filter (FILTER).

Filter (FILTER)

The filter varies the brightness of the sound by removing or boosting

certain portions of the frequency spectrum of the sound generated by

the oscillator. Filter settings will have a large impact on the character

of the sound. In addition, you can use envelope generator 1 (EG1) to

vary the cutoff frequency of each filter over time.

Amp (AMP)

This section consists of the amp (AMP) and pan (PAN) settings. The

amp specifies the volume, and the pan specifies the stereo position

of the sound. You can also use envelope generator 2 (EG2) to vary

the volume over time.

Envelope generators (EG1, EG2)

An envelope generator applies time‐variant change to parameters that

make up the sound. Each envelope generator defines the “shape” of

the time‐variant change using four parameters: attack time, decay

time, sustain level, and release time. EG1 is assigned to control the

filter cutoff frequency, and EG2 is assigned to control the amp volume.

You are also free to use an envelope generator in conjunction with a

virtual patch as an envelope source for another parameter.

LFOs (LFO1, LFO2)

An LFO (Low Frequency Oscillator) applies cyclic change to

parameters that make up the sound. Each timbre has two LFOs, each

giving you a choice of five waveforms. LFO2 is assigned as the

source of the pitch modulation controlled by the joystick. You are

also free to use an LFO in conjunction with a virtual patch as a

modulation source for another parameter.

Virtual patch (VIRTUAL PATCH)

The virtual patch functionality lets you use not only EG or LFO but

also sources such as velocity (keyboard playing strength) and

keyboard tracking (the keyboard region that you play) as

modulation sources to control the parameters that make up the

sound. This gives you a great deal of freedom in creating original

sounds. For each timbre, you can create virtual patch settings for six

parameters. (PG: “1. Timbre parameters”)

Master effects (MASTER FX)

Each program contains three types of master effect. By applying an

effect to each timbre, you can add finishing touches to the overall

sound of the program.

Arpeggiator (ARPEGGIATOR)

The arpeggiator automatically generates an arpeggio (broken chord)

when you hold down a chord on the keyboard. For programs that

use two timbres, you can apply the arpeggiator to either or both

timbres. This is a step arpeggiator with six arpeggio types.

2. Vocoder (VOCODER)

A vocoder analyzes the frequency characteristics of one signal called

the “modulator” (such as a human voice input via a mic) and applies

these characteristics to a filter that is processing a different signal

called the “carrier” (such as an oscillator waveform), thus producing

distinctive effects such as an instrument that appears to be talking.

The KingKORG contains a sixteen‐band vocoder that can not only

simulate not the classic vocoder sounds of the past but it can also

create original vocoder sounds where the tonal character or the level

of each band can be controlled. As shown in the illustration below,

the vocoder consists of the carrier (the signal being modified), the

modulator (the signal that controls the modifying), and the vocoder

section (VOCODER) itself.

Korg KingKorg Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info