12
Flushing the Water System
1. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for
5 seconds.
Repeat until water begins to flow.
2. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5
seconds off) until a total 15 litres has been dispensed. This will flush air from the filter and water
dispensing system, and prepare the water filter for use. Additional flushing may be required in some
households.
As air is cleared from the system, water may spurt out of the dispenser.
The Water Dispenser
IMPORTANT: Dispense enough water every week to maintain a fresh supply.
To Dispense Water:
1. Press a sturdy glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when the dispenser lever is pressed. To turn
off the ice maker, see “Ice Maker and Storage Bin.”
Your ice maker can produce both crushed and
cubed ice. Before dispensing ice, select which type
of ice you prefer by pressing the ICE TYPE button.
The display screen indicates which type of ice is
selected.
For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing
crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size.
When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first
cubes.
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch between cubed and crushed, press ICE TYPE.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the ice dispenser lever. Hold the glass close to the dispenser opening so ice
does not fall outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to the lever in order to activate the ice
dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for up to 10 seconds after removing the glass from the lever. The
dispenser may continue to make noise for a few seconds after dispensing.
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
If you want the light to be on continuously, you may choose either ON or DIM. The display screen
indicates which mode is selected.
ON: Press LIGHT to turn the dispenser light on.
DIM: Press LIGHT a second time to select DIM
mode. The dispenser light will remain on, but at a
lower intensity.
OFF: Press LIGHT a third time to turn the
dispenser light off.
The dispenser lights are LEDs that cannot be changed. If it appears that your dispenser lights are not
working, see “Troubleshooting” for more information.
WARNING
CRUSHED CUBED
ON DIM
