11
Removing and Replacing Ice Storage Bin
To Remove the Ice Storage Bin:
1. Hold the base of the storage bin and press the release button.
2. Pull out the storage bin.
To Replace the Ice Storage Bin:
IMPORTANT: It may be necessary to turn the
auger driver, behind the ice bin, counterclockwise
to properly align the ice bin with the auger driver.
The ice storage bin must be locked in place for
proper ice dispensing.
1. Slide the ice bin into the guide rails located on
either side of the enclosure.
2. Push the ice bin in until resistance is felt. Raise
the front slightly and push the ice bin in until an
audible “click” is heard.
Ice Production Rate
• Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.
• The ice maker should produce approximately 8 to 12 batches of ice in a 24-hour period.
• To increase ice production, lower the freezer and refrigerator temperature. See “Using the Controls.”
Wait 24 hours between adjustments.
NOTE: Setting the freezer to a colder temperature may make some foods, such as ice cream, harder.
Remember
• The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid
connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage
parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make
sure the water softener is operating properly and is well maintained.
• Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice bin and
dispenser mechanism.
• Do not store anything in the ice storage bin.
WATER AND ICE DISPENSERS
NOTES:
• The display screen on the dispenser control panel will turn off automatically and enter “sleep” mode
when the control buttons and dispenser levers have not been used for 2 minutes or more. While in
“sleep” mode, the first press of a control button will only reactivate the display screen, without changing
any settings. After reactivation, changes to any settings can then be made. If no changes are made within
2 minutes, the display will re-enter “sleep” mode.
• The dispensing system will not operate when the refrigerator door is open.
• Allow 24 hours for the refrigerator to cool down and chill water.
• Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.
Cleaning, Sanitizing and Maintenance
IMPORTANT: Failure to follow the instructions regarding sanitizing can compromise the hygienic safety of
the water dispensed.
• When using the refrigerator for the first time, and each time the water filter is changed, flush the water
system. Discard the first 15 litres of water, equivalent to 6 to 7 minutes of dispensing (not necessarily
consecutive, but before initial consumption) and discard the ice produced in the first 24 hours.
• If the water dispenser has not been used for more than 5 days, it is advisable to clean the circuit and run
off the first litre of water.
• Clean the ice bin regularly using only drinking water for cleaning the ice bin.
• The water filter must be changed when indicated on the control panel or when the ice/water dispenser
has not been used for more than 30 days.
• With each water filter replacement, sanitise the ice and /or water dispensing system using a food grade
disinfectant (with sodium hypochlorite), which does not alter the characteristics of the materials, or use
the “Sanitising Kit” available from the After-Sales Service. Rinse with at least 2 litres of water before use.
• Only original spare parts supplied by the manufacturer should be used when replacing components in
the ice and water dispenser.
A. Auger driver
