10
After unpacking the product, check for any damage
during transport.
In case of problems, contact the dealer or the After-
Sales Service.
For built-in dimensions and installation instruction,
see the pictures in page 5.
PREPARING THE CABINET FOR FITTING
- The lower part of the product must not be
accessible after installation.
- Do not fit the separator panel if an undertop
oven is installed.
These instructions are aimed at qualified fitters as a
guide to installation, adjustment and maintenance
in compliance with the laws and standards in force.
The operations must always be carried out with the
appliance disconnected from the electricity supply.
Positioning
The appliance is made to be fitted into a counter
top, as show in the figure. Apply the sealant
supplied around the whole perimeter of the hob.
Installation over an oven is not recommended, but
if this is necessary, check that:
- the oven has an efficient cooling system;
- there is no passage of hot air from the oven to
the hob;
- allow air passages as shown in the figure.
Electrical connection
Before connecting to the electricity supply, ensure
that:
- the characteristics of the system are such as to
satisfy that indicated on the registration plate
applied to the bottom of the hob;
- the system has an effective earth connection
compliant with the standards and laws in force.
Connection to earth is compulsory by law.
If the appliance has no cable and/or plug, use
material suitable for the absorption indicated on the
registration plate and for the working temperature.
The cable must not reach a temperature higher than
50°C above room temperature in any point.
For direct connection to the network it is necessary
to fit an omnipolar switch of a suitable size to
ensure disconnection of he network with a contact
opening distance that allows complete
disconnection in the conditions of the overtension
category III, compliant with the installation
regulations (the yellow/green earth wire must not
be interrupted).
The omnipolar socket or switch must be easy to
reach when the appliance is installed.
N.B.:
- The manufacturer declines all responsibility if
the usual accident prevention standards and the
above instructions are not observed.
If the power cable is damaged, it must be replaced
by the manufacturer or by the manufacturer’s
technical servicing network, or by a similarly
qualified operator, to prevent every possible risk.
WARNING
Installation
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to
property resulting from failure to observe the regulations provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the
same as that of the home.
WARNING
Electrical connection
