80
SXRC Remote Control
Service
With the screws removed, carefully
lift the top cover off the SX Interface
Box.
With the top removed you can now
see the 3 amp fuse held in place by
two fuse clips.
Examine the fuse visually and see if
it is blown and needs replaced.
If blown, then gently pry the fuse up
and away from the fuse clips using a
small screwdriver.
Press in the new fuse until it locks fully
into place.
You can now re-assemble the Interface
Box following the above instructions in
reverse.
NOTE:
Just a reminder that you should be very careful with the top
cover removed from the Interface Box as to not damage any of
the components inside. NEVER use a fuse with a higher rating
than 3 amps. DO NOT connect the power harness to the
Interface Box until it is fully assembled.
Interface Box Fuse
The SXRC is protected by a fuse which is internally mounted in
the Interface Box. If you ever need to replace this fuse an extra
one has been supplied with your SXRC kit. If you lose this fuse or
ever need another one, please replace with the the same size
and style of fuse.
To replace the fuse, first
disconnect the power harness
from the SX Interface Box.
Next, remove the
four screws holding
the Interface Box to
its mounting sur-
face.
Now, remove the
two screws on the
side of the Interface
Box which secure the
top cover/mounting
base to the bottom.