UTILITY
Introduction
In the main display screen, press the F3 function button to have access to the Utility section, which
is made up of 3 pages, each one of which can be selected by means of the special page > < buttons
on the top right-hand side of the front panel of the instrument.
The first page is as follows: in the middle of the display panel, the current style is indicated, along
with the tempo value, the transposer, the level of the left split of the keyboard, the main sound and
the secondary one. This display is constant throughout all 3 pages. On the right- and left-hand side
of the display panel, the various functions relating to the respective buttons appear, and these vary
from page to page.
PAGE 1 UTILITY
OCTAVE (F1)
The Octave function enables the immediate transposition
by one octave down or up (+/- 12 semitones) over the
entire keyboard. To enable this function simply press the
Octave key.
The octave selection is achieved in the following manner:
1 Press the F3 key – Utility.
2 The Octave change is associated with function key F1. Down corresponds to the lower
Octave; Up to the higher Octave.
Using the Power On Set Up function it is possible to establish which of the two options, Down and
Up is always enabled when the instrument is switched on (See the Power On Set Up paragraph).
The Down or Up function of the Octave may also be saved in Registration.
AFTER TOUCH (F2)
On the contrary to the Velocity Key that controls the velocity with which the key is pressed, the
After Touch controls the pressure applied to the key after it has reached the end-of-stroke. In other
words, the After Touch starts to work when a key is pressed harder than usually done so to play.
To gain access to the After Touch controls:
1 Press the After Touch key.
2 Press key F 3 – Utility .
3 Enable the After Touch function using key F2.
Cut Off: control of the Filter associated with the After
Touch. The parameter is enabled using the F1 key.
Lfo Dco, Dcf, Dca: 3 modulation controls associated
with the After Touch and relative to the Oscillator (Dco), Filter (Dcf) and amplitude (Dca)
respectively. The 3 parameters are selected using keys F 2, F 6 and F 7.
Bend: when Bend is pressed, the After Touch function shifts the tuning upwards or downwards,
depending on whether the Bend value is positive or negative. This movement is performed in
semitones, with a range of + / - 24 semitones. Use key F 3 to select the Bend parameter and the
Value + / - keys to modify the value.
23
