803817
10
Verklein
Vergroot
Pagina terug
1/132
Pagina verder
English 11
Pressure relief
1. Open and close connected stop valves for pressure
relief.
The system is depressurised.
Note
Rinse the pump with clear water after each use when
pumping water with additives.
Check the pressure of the air filling in the
storage tank
1. Check the pressure of the air filling in the storage
tank every six months, if necessary top up to 2.0 bar
when the device is switched off/depressurised (un-
plug the device, open the water tap)
Note
The type plate is located below the cover. Unscrew the
cover in an anti-clockwise direction.
Illustration B
Transport
CAUTION
Risk of injury
Risk of injury from falling device.
When transporting the device, observe the weight of the
device (see chapter Specifications) and secure it ac-
cordingly when transporting it in vehicles.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
1. Empty the device completely before storage.
2. Store the device in a frost-protected place.
Special accessories
You will find the possible special accessories on the last
page of these operating instructions.
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Fault Cause Rectification
Pump is running, but not
delivering
There is air in the pump. 1. See chapter Preparation
The air cannot escape on the pressure
side.
1. Open the tapping point on the pressure
side.
No water available. 1. Check the water reservoir.
The pump does not start
up, or stops suddenly
during operation
The power supply is disconnected. 1. Check the fuses and the electrical connec-
tions.
Thermal protection switch in the motor
has switched off the pump due to over-
heating of the motor.
1. Pull out the mains plug.
2. Allow the pump to cool down.
3. Clean the suction area.
4. Prevent dry running.
Note
The cooling time until the motor starts can be
up to 150 minutes.
The pump switches itself
off and also on again
The thermal protection fuse has switched
off the pump to protect it from overheat-
ing or switched it on again after it has
cooled down.
1. To prevent recurrence, the system should
be checked for leaks and sealed.
The motor restarts imme-
diately after switching off
The pressure in the system is lost. 1. Check the connections including seals and
check for water leakage. The slightest
leakage affects operation.
The air pressure in the storage tank is too
low.
1. Fill the storage tank with 2.0 bar (see chap-
ter Care and maintenance).
The return valve does not close properly. 1. Check the check valve on the suction side.
The membrane in the pressure tank is
defective.
1. Have the membrane replaced.
The pump capacity drops
or is too low
The suction filter or the check valve (spe-
cial accessory) are contaminated.
1. Clean the suction filter or the check valve
(special accessory).
The delivery rate of the pump depends
on the delivery head and the connected
periphery.
1. Observe the max. delivery head (see chap-
ter Specifications) Select a different hose
diameter or a different hose length if nec-
essary.
Vibrating noise during
water removal
The membrane in the pressure tank vi-
brates.
1. An operating noise that can be eliminated
by reducing the pressure of the air filling in
the storage tank.
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Karcher BP 3.200 Home bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Karcher BP 3.200 Home in de taal/talen: Alle talen als bijlage per email.

De handleiding is 3.44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info