636490
38
Verklein
Vergroot
Pagina terug
1/116
Pagina verder
Engineering information and sizing the heat source
6 720 645 817 (2010/09)
38
Water treatment measures
There are two methods for treating the fill and top-up
water for Suprapur gas condensing boilers:
Use of fully desalinated fill water with a conductivity
of 10 μS/cm:
During the total desalination of the fill and top-up
water, not only the causes of hardness (Ca, Mg) but
also all other minerals are removed. This significantly
reduces the conductivity of the fill and top-up water.
The likelihood of corrosion forming shrinks as the con-
ductivity of the heating water drops. Operation with a
low salt content will at the same time reduce corro-
sion in the heating system.
Use of partially softened fill and top-up water based
on sodium ion exchangers:
The fill and top-up water must have a residual
hardness of 5 °dH to 7 °dH.
Only use chemicals approved by Junkers.
Additional protection against corrosion
Damage through corrosion occurs if oxygen constantly
enters the heating water, for example through
inadequately sized or faulty expansion vessels (MAG) or
open vented systems.
If a sealed unvented heating system is not feasible,
corrosion protection measures are required, e.g. by
adding approved chemicals or by system separation
through the use of a heat exchanger.
Installation in existing heating systems/dirt traps
If the gas condensing boiler is installed in an existing
heating system, impurities may build up in the boiler,
leading to local overheating, corrosion and noise.
We therefore recommend the installation of a dirt trap
and blow-down facility. This should be installed
immediately between the boiler and the lowest position
with good accessibility, and should be cleaned during
every service.
Estimate of system capacity
Especially with older systems, the water capacity of the
entire system is often not known. The following graph
gives an estimate of the system capacity.
Fig. 24 Estimated water capacity of the system with
known system output
Q Total system output
V Water capacity
1 Steel/cast iron radiators with pipes sized for gravity
circulation and underfloor heating (20 l/kW)
2 Panel radiators (10 l/kW)
3 Convectors (6 l/kW)
0
1
2
3
4
5
6
7
8
9
10
11
12
0 100 200 300 400 500 600
1
2
3
V
[m
3
]
Q
[kW]
6 720 642 877-13.1il
.
38

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Junkers MKB 560-3 A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Junkers MKB 560-3 A in de taal/talen: Engels als bijlage per email.

De handleiding is 15,83 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info