10
10X MANUAL Heli
It is extremely important that your radio system be correctly
installed in your model. Here are a few suggestions on the
installation of your
JR equipment:
1. Wrap the receiver in protective foam rubber that is no
less than 3/8 inch thick. Secure the foam to the receiver with
#64 rubber bands. This will protect the receiver in a crash or a
very hard landing.
2. The servos should be mounted using rubber grommets and
brass bushings to isolate them from vibrations. Do not over-
tighten the mounting screws — this will negate the vibration
absorption effect of the rubber grommets. The diagram at right
will assist you in properly mounting your servo.
The brass bushings are pushed from the bottom up in the rubber
grommets. When the servo screw is tightened securely, this will
provide the proper security as well as the proper vibration isola-
tion for your servo.
3. The servos must be able to move freely over their entire
range of travel. Make sure that the control linkages do not bind
or impede the movement of any of the servos.
4. Mount all switches away from the engine exhaust and
away from any high vibration areas. Make sure the switch oper-
ates freely and is able to operate over its full travel.
5. Mount the receiver antenna firmly to the helicopter to
ensure that it will not become entangled in the main and/or tail
rotor blades of your helicopter.
Connections
4
4.2
Connections
FM Rx
D72.550
BATT
AUX 5
AUX 4
AUX 3
AUX 2
AUX 1
GEAR
RUDD
ELEV
AILE
THRO
ON
OFF
Auxiliary 5
Auxiliary 4
Auxiliary 3/Gyro Gain
Auxiliary 2
Auxiliary 1/Pitch
Gear
Rudder
Elevator
Aileron
Throttle
NER-950S
S-PCM Receiver
Deluxe Switch Harness
JRPA001
Chargecord or
D.S.C. Receptacle
JRPA024
Chargecord or
D.S.C.
D.S.C. – JRPA123
Chgr. – JRPC222
Receiver Battery
1400mAh Sanyo Extra NiCad
JRPB4340
10 CH S-CLASS PCM RECEIVER
JAPAN REMOTE CONTROL CO., LTD
MADE IN JAPAN
ABC&W INTERFERENCE
PROTECTION SYSTEM
