Message Cause Action
Reference station communi-
cation problem
There is no radio signal between the
product and the reference station.
Do a pairing operation between the prod-
uct and the reference station.
The reference station is not installed cor-
rectly.
Examine the installation of the reference
station. Refer to the Operator's manual
for the Reference station.
The product does not receive the radio
signal from the reference station in all of
the work area.
Examine if the product has radio signal
from the reference station in the full work
area. If not, make a new installation of
the reference station or a new installation
of the map. Refer to
Installation of the
map objects on page 21
.
Install a second reference station to op-
erate as a repeater. Make sure that the
product can receive the radio signal.
Speak to your Husqvarna representative
for more information.
Power failure. Examine and correct the cause for the
power failure of the reference station.
Install a second reference station to op-
erate as a repeater. Speak to your Husq-
varna representative for more informa-
tion.
There is an error in the reference station
and the LED indicator flashes red.
Disconnect the power to the reference
station and connect it again to restart the
reference station. If the problem stays,
speak to your approved servicing dealer.
Unexpected cutting height adj
The cutting height adjustment cannot
move.
Examine the cutting height adjustment
and remove grass or other objects. If the
problem stays, speak to your approved
servicing dealer.
Limited cutting height range
Cutting height problem
Cutting height blocked
Cutting deck not in correct
position
The cutting deck is not attached correct-
ly.
Make sure that the cutting deck is at-
tached correctly and that the lever is in
the correct position. If the problem stays,
speak to your authorized service center.
The cutting deck is in service position. Make sure that the cutting deck is in cut
position. If the problem stays, speak to
your authorized service center.
Destination not reachable
There is no transport path between the
charging station and the work area or
maintenance point.
Make a transport path between the
charging station and the work area or
maintenance point.
The transport path is blocked and the
product cannot go to the work area,
charging station or maintenance point.
Make sure that the transport path is not
blocked, or delete the transport path and
make a new transport path.
Too many waypoints
There are too many waypoints in the cur-
rent work area.
Make a new the work area, stay-out
zone and transport path and use less
waypoints. Divide the current work area
into more work areas.
1691 - 007 - 22.12.2023 Troubleshooting - 45
