Warning: Do not put any vinegar, hot water, perfume, or any other kind of chemical
agents or any other contents in the water tank. It could damage the steam
generator and shorten its life use.
Domestic Iron Models:
Connect the appliance with the mains cord to the earthed socket. Press on the on/
o switch. The light of the on/o switch (1a) will switch on and inform you that the
appliance is running on and that the boiler is heating up.
After approximately 2 minutes, the “steam ready” led will light o informing you that
you can start using steam.
Professional Iron Models:
Connect the appliance with the main cord to the earthed socket. Press the iron on/
o switch (1g) and the boiler on/o switch (1f). The lights of both switches should
turned up and inform you that the appliance is running on. The iron soleplate and
the boiler are heating up.
N.B.
The rst time the appliance is used, some fumes and smell should appear. It’s quite
normal and will disappear quickly.
Chapter 2.3 - Switching on the Appliance
Chapter 3: Using Your Steam Generator
Select the temperature of the soleplate by turning the dial (12) on the iron to the
desired position. Wait a few moments until the temperature indicator (15) is o. It
will indicate you that the soleplate has reached the requested temperature.
While ironing, the temperature dial indicator turns on and o, as the temperature
adjusts without interrupting ironing.
Help:
To know the best suitable temperature for each textile, check the laundry care label of
the article to be ironed. Please note that during use, the temperature light goes on from
time to time. It signies that the iron is heating up to the set temperature.
If a fabric is made with various kinds of bres always select the soleplate temperature in
adequacy with the most delicate one.
If you select a lower temperature while ironing, wait until the iron has cooled down to
the set temperature before you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate.
Please raise up the temperature above the 2 dots (••) to avoid this issue
Chapter 3.1 - Regulating the Soleplate Temperature
GB
