Starting the cycle
Press the Start Pause button. The door locked indicator and
the START light illuminate, within a few seconds the
programme will begin.
Do not try to open the door when the door locked indicator is
on.
Do not open the dispenser drawer during the wash
programme.
If you wish to pause the programme press the Start Pause
button; after two minutes you will be able to open the door.
To cancel the programme the programme selector should be
turned to the OFF position. A new programme can be selected
after cancelling the previous programme.
To test the laundry for dryness
When completing the drying phase it is possible to check the
load for dryness.
Press the Start Pause button, the machine will go into pause
mode indicated by the COUNTDOWN display time and the
option buttons flashing.
After 2 minutes the Door Locked light will go out indicating
that the door can be opened and the load checked.
Be very careful as the load and door glass may be very hot.
To continue close the door and press the Start Pause button.
The programme will restart and continue for the remaining
time.
When the programme has finished
Wait approximately two minutes for the door lock to be
released. The door locked indicator will go out and it will then
be safe to open the door.
Switch off the machine by turning the programme selector to
the OFF position so that it will be ready the next time you use
the machine (this action resets the memory in the machine).
Open the door.
Remove the laundry.
Disconnect the plug from the mains power supply and turn off
the water supply whenever you finish using it.
25
