700148
19
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
19
OPERATING INSTRUCTIONS
FUNCTIONS AND OPERATIONAL CONTROLS
POWER
PROTECT
L
R
SLAVE INPUT LINE OUTPUT
MASTER OUTPUT
SUB BOOST Q-CONTROL FREQ RANGE PHASE SHIFT SUB SONIC LOW PASS
LEVEL REMOTE IN REMOTE OUTBALANCED INPUT
LINE INPUT
L
R
EXTENDED BASS CONTROL
MASTER SLAVE
OPERATION MODEX-OVER MODE
FULL LP
5 6 71 3 4 92 10 118 12
The PHASE SHIFT controller allows to adjust the phasing between 0° and 180°. Thereby you are able to adjust the
subwoofer perfect to the vehicle’s acustics.
The OPERATION MODE switch selects the required operation mode of the amplifier.
In the SLAVE-Mode the amplifier works as a SLAVE amp, this means only the audiosignal of the MASTER amp will be amplified.
All controllers on the SLAVE Amp are without function and will be assumed by the MASTER amp.
In the MASTER-Mode all controllers are active.
NOTE: By using only one amplifier, the Mode-Switch must set to the position MASTER.
The MASTER OUTPUT/SLAVE INPUT jacks are suitable to connect an additional amplifier in MASTER/SLAVE mode.
Attend therefor the chapter Interconnection Example: MASTER/SLAVE on page 21.
1
The LINE INPUT RCA jacks must be connected with the RCA output jacks of the headunit.
2
The optional BALANCED INPUT is unlike the regular RCA-cables insusceptible against interspersion and interferences of the
vehicle’s electronics. You need therefor a Balanced-Line-Transmitter with a special cable, which can be connected between the
head unit and the amplifier. The Balance-Line-Transmitter is not included in delivery.Never use the Balanced-Input and the
RCA-Inputs at the same time.
4
The LOW PASS controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously
adjustable from 40 Hz to 250 Hz.
5
7
8
The LEVEL controller adjusts the input sensitivity of the amplifier to align the audio signal from the head unit.
The input sensitivity is adjustable from 9 to 0.2 Volts.
The REMOTE IN port is for the cable of the enclosed bass remote controller and only to use in the LP/BP mode. With this bass
remote controller, you are able to adjust the bass level e.g. out of the driver’s seat. Please use only the enclosed bass remote
controller and cable.
The REMOTE OUT port is suitable to connect the bass remote link cable of an additional amplifier of the HiFONICS X3 or X4
Series (only in MASTER-Mode). Hence, you are able to control several amps with only one bass remote. Check Page 23.
9
3
The SUB SONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid
a mechanical and electrical overloading on the subwoofer. The range is adjustable from 15 to 55 Hz and depends on the size
of the subwoofer. NOTE: If this controller is turned to a higher value than the LOW PASS controller, no sound is hearable.
6
10
11
POWER/PROTECT
If the POWER LED lights up, the amplifier is ready for operation.
If the PROTECT LED lights up, a malfunction is indicated. Please note the chapter TROUBLE SHOOTING.
12
The LINE OUTPUT RCA jacks provide a linear audiosignal to supply an additional amplifier.
The EXTENDED BASS CONTROL controllers allow a extensive adjustment of the bass frequencies.
The SUB BOOST controller defines the bass bosst from 0 to 18dB. With the FREQ RANGE controller you are able to adjust,
on which frequency the bass boost (SUB BOOST) is effictive. The range goes from 20 to 80 Hz.
With the Q CONTROL controller defines the Q-Factor of the crossover continuously, so that
the playback quality of the cut-off frequency can be adjusted. Thereby you are able to adjust
perfect transitions between the loudspeakers.
WIDE Q-Factor of Q 0,3 (arrow left below) = very wide frequency range.
NARROW Q-Factor of Q 1,0 (arrow right below) = very narrow frequency range.
Q 0,5 LINKWITZ-REILLY (Standard-setting, 12 o’clock position).
• Q 0,7 BUTTERWORTH (3 o’clock position)
The X-OVER MODE switch selects the required operation mode of the amplifier.
In the LP-Mode (Low Pass mode) you are able to limit the frequencies to above or below with the LOW PASS or SUBSONIC
controller.
In the FULL-Mode a full range signal will be provided to the speakers. The controllers PHASE, LOW PASS, SUB SONIC and
the BASS REMOTE are without function.
+6dB
+12dB
+18dB
0dB
20Hz 40Hz 60Hz
Q = 1,0
Q = 0,3
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hifonics X4-Atlas bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hifonics X4-Atlas in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 3,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info