502558
34
Verklein
Vergroot
Pagina terug
1/68
Pagina verder
34 SYSTEM CONFIGURATION
System Configuration
Sub Mode Setting
When the Front Left/Right speakers are con-
figured as “Large” and a subwoofer is detected
by EzSet/EQ or manually configured as being
available, additional options are available to
further customize bass redirection. To change
these settings, first make sure that the
SPEAKER SIZE menu (Figure 19) is on the
screen, and then press the
/
¤
Navigation
Button
E
so that the cursor is pointing to
SUB MODE. Press the
/
Navigation
Button
E
to begin the selection process, and
note that the warning message (Figure 20) will
appear reminding you to rerun EzSet/EQ after all
changes have been made.
The following options are available:
The default setting for Large front left/right
speakers when a subwoofer is present is
SUB
L/R + LFE
. In this mode, all sounds below
the crossover point set on the
LFE LP FLT
line will be sent to BOTH the subwoofer and
the front left/right speakers.
To send only the LFE channel information to
the subwoofer, but have all other (“derived”)
low-frequency sounds sent to the front
left/right speakers, select the
SUB (LFE)
setting.
To have low-frequency information sent to the
subwoofer only when Large speakers are
selected, choose
SUB (L/R).This option is
only available when the unit is set to
SURROUND OFF so that a pure analog
audio path is provided.
When no subwoofer is present and Large
speakers are configured for the front left/right
position, select
NONE. This will route all low-
frequency information to the front left/right
speakers.
When the SPEAKER SIZE menu returns to
the screen, replacing the warning message, press
the
/
Navigation Button
E
to make your
selection. When the desired setting appears,
press the
/
¤
Navigation Button
E
to
move the cursor to any other line on this menu
where you wish to make a setting change, or go
to the
BACK TO MANUAL SETUP menu
and then press the Set Button
F
to continue
with overall configuration.
Subwoofer Size
The final setting on the
SPEAKER SIZE
menu enables you to change the setting for the
subwoofer size. In the event that EzSet/EQ did
not accurately enter the correct size, or if you
wish to experiment with a different setting, first
make sure that the
SPEAKER SIZE menu
(Figure 19) is on the screen; then press the
/
¤
Navigation Button
E
so that the cursor is
pointing to
SUB SIZEand then press the
/
Navigation Button
E
to begin the selection
process. Note that a warning message will
appear for 4 seconds to remind you to rerun
EzSet/EQ after all changes have been made.
Select a setting that best matches the diameter
of your subwoofer’s driver, or which provides the
appropriate high-pass filter setting for your sys-
tem. In each case, the frequency of the high-pass
filter determines the frequencies below which no
information is sent to the subwoofer:
The setting for an 8-inch/200mm driver
activates a 38Hz subwoofer high-pass filter.
The setting for a 10-inch/250mm driver
activates a 30Hz subwoofer high-pass filter.
The setting for a 12-inch/305mm driver
activates a 20Hz subwoofer high-pass filter.
The setting for a 15-inch/380mm driver
activates a 15Hz subwoofer high-pass filter.
When all changes to Speaker-related settings
have been made, press the
/
¤
Navigation
Button
E
until the cursor is on the BACK
TO MANUALSETUP
menu and then
pressing the Set Button
F
so that you may
make any other adjustments to the system
parameters. It is also important to remember to
rerun the EzSet/EQ system if any changes have
been made to the settings on this menu,
following the instructions shown on page 33 for
using the Manual mode.
The Speaker Configuration may also be changed
at any time without using the full-OSD on-screen
menu system by pressing the Speaker Selector
6
on the front panel or
b
on the remote
control. Once the button is pressed,
FRONT
SPEAKER
will appear in both the lower third
of the video display and the Main Information
Display
˜
.
Within five seconds, either press the
/
buttons
7$
on the front panel or the
/
¤
buttons
E
on the remote to select a different speaker
position, or press the Set Button
@
F
to
begin the adjustment process for the front left
and right speakers.
When the Set button
@
F
has been pressed
and the system is ready for a change to the front
speaker setting, the on-screen display and Main
Information Display
˜
will read FRONT
LARGE
or FRONT SMALL depending on
the current setting. Press the
/
buttons
7$
on the front panel or the
/
¤
buttons
E
on
the remote until the desired setting is shown,
using the instructions for “large” or “small”
shown earlier, then press the Set button
@
F
.
If another speaker position needs to be changed,
press the
/
buttons
7$
on the front panel
or the
/
¤
buttons
E
on the remote to
select a different speaker position, press the Set
button
@
F
and then the
/
buttons
7$
on the front panel or the
/
¤
buttons
E
on
the remote until the correct speaker setting is
shown and press the Set button
@
F
again
to confirm the selection.
To assist in making these settings, the icons in
the Speaker/Channel Input Indicators
Ú
will change as the speaker type is selected at
each position. When only the inner icon box is lit,
the speaker is set for “small. When the inner box
and the two outer boxes with circles inside them
are lit, the speaker is set for “large." When no
indicator appears at a speaker location, that
position is set for “none” or “no” speaker.
Note: These icons are available only when
making setup changes without the use of the full
OSD mode.
As an example, in the Figure below, all speakers
are set for “large, and a subwoofer is set.
Delay Settings
Due the different distances between the listening
position for the front channel speakers and the
surround speakers, the amount of time it takes
for sound to reach your ears from the front or
surround speakers is different. You may
compensate for this difference through the use of
the delay settings to adjust the timing for the
specific speaker placement and acoustic
conditions in your listening room or home
theater.
29851_AVR645_ENG 30/10/06 9:46 Side 34
34

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon AVR645 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon AVR645 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Harman Kardon AVR645

Harman Kardon AVR645 Gebruiksaanwijzing - Nederlands - 68 pagina's

Harman Kardon AVR645 Gebruiksaanwijzing - Deutsch - 68 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info