502541
28
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
28
28
INSTALLATION
remote control to operate the iPod, and even charge the iPod while
it’s docked in The Bridge.
Simply plug the proprietary cable from The Bridge into the special
The Bridge/DMP connector on the rear of the AVR 347. See Figure 29.
Refer to the owner’s manual for The Bridge to select the appropriate
insert to match your iPod.
Figure 29 – The Bridge/DMP Connector
Step Five – Connect Video Display
Only video connections should be made between the receiver and
your video display (TV), unless your TV is the source for your television
programming (see Video 3 Source on page 26).
If you used an HDMI video connection for any of your sources, then con-
nect the HDMI Output on the AVR to an HDMI input on your video display.
See Figure 30. Consult the owner’s guide for your television to learn
the proper procedure for disabling or muting the audio. Unless you have a
non-HDMI source device that outputs 1080i or higher video via an analog
component video connection (see note below), no other video connections
are required, thanks to the AVR 347’s ability to transcode analog video
signals to HDMI, and you may proceed to Step Six.
IMPORTANT NOTE: The AVR 347 cannot convert 1080i or
1080p analog video signals to the HDMI format and outputs 1080i
signals, as is, to the Component Video Outputs. This affects users
of Microsoft Xbox 360 systems and some older set-top boxes.
If your digital cable television set-top box outputs 1080i or higher
video via component video outputs only contact your cable operator
for a replacement unit equipped with an HDM output.
For Xbox 360 or satellite receivers with no HDMI output, connect
the AVR’s Component Video Monitor Outputs to the TV, or change
the settings on your source device so that it outputs only 720p
video through its component video outputs, which the AVR can
convert to the HDMI format. Although you could connect the source
device’s component video outputs directly to your video display, you
would then have to select the correct video input on the display to
match the AVR’s input.
Figure 30 – HDMI Output
If your television does not have HDMI or DVI video inputs, you will need
to make a video connection for each type of video used for your sources.
First, determine what types of video your display is capable of handling.
Component video is preferred, followed by S-video and then composite
video. Ideally, this guided you in selecting the video connections for your
sources.
Next, note which types of video connections you used for your source
devices. Make sure you didn’t use a better type of video connection
for a source than your video display can handle. If so, disconnect the
source and use a video connection that’s compatible with your display.
If you used component video for any sources, connect the Component
Video Monitor Outputs on the receiver to one set of component video
inputs on your display. See Figure 31. The AVR 347 is able to transcode
composite and S-video sources to component video. If your video dis-
play has component video inputs, then you need only to connect the
Component Video Monitor Outputs and you may proceed to Step Six.
Figure 31 – Component Video Monitor Outputs
If you used S-video for any sources, connect the S-video Monitor output
on the receiver to an S-video input on your display. See Figure 32. The
AVR 347 converts composite video sources to S-video. If your video
display has S-video inputs, then you need only to connect the S-Video
Monitor Output and you may proceed to Step Six.
If you used composite video for any sources, but not component video
or S-video, connect the Composite Video Monitor output on the receiver
to a composite video input on the display. See Figure 32.
Figure 32 – S-Video and Composite Video Monitor Outputs
Consult the manual for your TV to make sure you understand how to
select each video input.
Step Six – Plug in AC Power
Having made all of your wiring connections, it is now time to plug each
component’s AC power cord into a working outlet.
You may plug one device into the AC Switched Accessory Outlet on the
rear of the AVR 347. See Figure 33. Make sure this device draws no
more than 50 watts. The device should have its mechanical or master
power switch turned on, and it will power on any time the AVR 347 is
turned on.
Figure 33 – Switched AC Accessory Outlet
Before plugging the AVR 347’s AC Power Cord into an electrical outlet,
make sure that the Master Power Switch on the front panel is popped
out so that the word OFF appears on its top. Gently press the button to
turn the switch off. This will prevent the possibility of damaging the AVR
in case of a transient power surge.
The AVR 347 is equipped with a detachable power cord. It allows
you to fully wire your system before installing the AVR, which may be
required for some in-wall entertainment centers or custom applications.
The male end of the cord should be plugged into an unswitched AC
power outlet, and the female end should be plugged into the receptacle
on the AVR 347’s rear panel. See Figure 34.
AVR347 om.qxd 7/10/07 11:01 AM Page 28
28

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Harman-Kardon-AVR-347

Zoeken resetten

  • Geachte heer, mevrouw,

    Hoe moet ik, om sacd's af te spelen, mijn Sony dvd/cd/sacd speler aansluiten op mijn Harman Kardon AVR 347? Op de speler zit een digitale coaxiale uitgang en een hdmi uitgang. Gesteld op 23-2-2021 om 14:07

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon AVR 347 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon AVR 347 in de taal/talen: Engels als bijlage per email.

De handleiding is 7,44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Harman Kardon AVR 347

Harman Kardon AVR 347 Gebruiksaanwijzing - Nederlands - 64 pagina's

Harman Kardon AVR 347 Gebruiksaanwijzing - Deutsch - 64 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info