0434515001403a 5
In order to avoid the temperature limiting device continually opening when there is too little heat consumption then a
buffer store is recommended. Discuss this with your heating engineer.
The electrical installation work should be carried out by a specialist. The rules and regulations of the VDE (German
Electrical Engineers Association) and the electricity supply companies are to be observed.
When working on electrical components (e.g. the pump and the pipe sensors) it is absolutely necessary to switch off
the current beforehand.
4. Emplacement
4.1. Minimum distances from inflammable construction parts:
As a matter of principle, the emplacement of a fireplace stove must observe the valid official fire-fighting
regulations.
In this respect, please observe the international regulations.
Caution! As minimum distances from inflammable materials or materials sensitive to heat (e.g. furniture,
wallpapers, wooden linings), or load-bearing walls respectively, there must be respected the distances shown in the
type plate.
In case of inflammable floorings or the flooring sensitive to heat, the appliance must be placed on an incombustible
floor plate (e. g. a glass panel) (see the drawing).
Caution! With a stove with lateral window, the same distance must be maintained as with the extent of
radiation in the front!
Recommended protection of the floor
A 50 cm –in the front
B 30 cm – from the inside edge of the combustion space
C 80 cm –extent of radiation from the window
Safety distances from inflammable construction parts:
In the rear: - see the type plate
On the side: - see the type plate
In the front in the extent of radiation: see the type plate
4.2. Inlet of combustion air
It is necessary to ensure that in the place of location of the stove there would be available sufficient combustion air.
4.3. Input connection of external air(provided it is installed)
We recommend to employ an input connection of external air for the
supply of combustion air, so that precious air from the living room might not
be consumed during heating.
We do not recommend to bring cold air from outside to the room by
means of direct conduction; it could bring about formation of condensate.
5. Operation of the fireplace stove
5.1. Suitable fuels
The fuels approved for combustion and the maximum stoking amounts of fuel are shown in the specification of the
appliance.
The length of the fuel varies from 29 cm to 33 cm, depending on the combustion chamber.
Orientating value (depending on the type of the wood):
1kg of fire wood = about 4kW
1kg of wood briquettes = about 5kW
Wood briquettes expand during combustion, and therefore, they ought to be broken to pieces.
