SETTINGS
_______________________________________________________________________________
ENGLISH
35
Note:
This applies both when reception unit B (INPUT B) is set to a decoder channel or a timer event
that requires the decoder is active.
It is only possible to change the decoder setting for channels of reception unit A (INPUT A) when
the reception unit B (INPUT B) is not using the decoder.
If reception unit B (INPUT B) is using the decoder the decoder setting field for channels of recep-
tion unit A (INPUT A) will appear as “– – –” and is not accessible.
During a timer event on reception unit B (INPUT B) where the channel being recorded is using
the decoder, the main menu only allows access to the timer sub-menu »1
:
Ȅ
«.
Video polarity
You can set a positive ”+” or negative ”– ” video polarity using the »
;;::
« button.
The ”
+” setting is pre-programmed. For some decoders, you may need the ”– ” setting.
The sub-menu »3:
//
« ( Baisc set-up)
1 Press the »Ǻ« button followed by the »3« button to display the Basic set-up sub-menu.
Key to the symbols:
/
1 Decoder mode selection 1-4 (e.g. 1 = Normal, CCVS)
{
125Contrast level 1 (preset value = 25)
{
211Contrast level 2 (preset value = 11)
))
–
Receiver lock “yes“
ENGLISH Language of the »1:
Ȅ
« timer sub-menu
Ǻ
Exit menu without saving
OK Save then exit menu
??
A 003
ʐʐ
11. 494 GHZ
$
H – A
ʀǁ
7.02 MHz 7.20 MHz
ǁ~ PANDA BW 1
((
–
{
1
//
– – –
= +
Ǻ / OK
//
1
{125
{ 211
))
–
ENGLISH
Ǻ / OK
