813412
19
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
19
2.32 Carefully lift the appliance into position.
Take care not to damage the floor finish.
Ensure all clearances to combustibles are observed, see
Site Requirements, Section 6.
2.33 Connect the gas supply to the gas Inlet pipe at the back of
the appliance.
3. Flue Assembly
3.1 See Site Requirements, Section 2, Flue Options.
TAKE CARE WHEN MARKING OUT FOR THE FLUE AS
IT IS DIFFICULT TO MOVE AFTER INSTALLATION. IF A
RESTRICTOR IS REQUIRED FIT THIS BETWEEN THE
SMALL OUTLET SPIGOT AND THE AIR DUCT, SEE
DIAGRAM 14. REFER TO TECHNICAL SPECIFICATIONS
FOR RESTRICTOR SIZE.
14
3.2 A 152mm (6") diameter hole in the wall is required to install
the flue. This can be achieved by using either:
a) Core drill
b) Hammer and chisel
3.3 Drill small holes around the circumference when using
method b). Make good both ends of the hole.
3.4 Allow enough room either above or to the side of the
appliance to assemble the flue on top.
3.5 Assemble a horizontal flue in the following order:
— Vertical section
— 90° elbow
— Horizontal plus terminal
3.6 Support the opening of a masonry installation with a lintel.
3.7 Only the horizontal terminal section can be reduced in size.
To find the length:
3.8 Measure from the outside of the wall to the stop on the
90° elbow.
3.9 Add 10mm to the outlet end.
3.10 Measure from the edge of the slots closest to the wall.
3.11 Mark around the flue, see Diagram 15.
15
10mm
A wall plate is supplied to fix the flue to the wall:
3.12 Bend the tab to 9.
3.13 Assemble the plate onto the flue but do not secure to wall
until the flue is fully assembled, see Diagram 15.
3.14 The cardboard fitment in the terminal is used to support the
flue whilst it is cut to length. ONCE CUT TO SIZE
REMOVE THE CARDBOARD REMNANT, see Diagram 16.
16
3.15 Remove the compression elbow from the appliance and
connect it to the gas supply pipe.
As the appliance is fitted into the enclosure:
3.16 Pass the elbow and supply pipe through the silicone panel
on the LEFT HAND side.
3.17 PURGE THE SUPPLY PIPE. This is essential to expel any
debris that may block the gas controls.
3.18 Connect the elbow to the appliance inlet pipe,
see Diagram 17.
17
Installation Instructions
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gazco Studio Freestanding Balanced Flue bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gazco Studio Freestanding Balanced Flue in de taal/talen: Engels als bijlage per email.

De handleiding is 8.63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info