813402
15
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
2.4 Gently remove the appliance from the crate and place into
its intended position. Locate the two securing holes in the
base subframe (those previously used to secure the
appliance to the crate), mark the positions on the floor and
place the appliance to one side (see Diagram 4).
4
AR1292
2.5 Drill the two holes and insert the wall plugs supplied. If the
gas supply is to enter through the floor under the appliance,
now is the time to make the necessary provision for the gas
supply.
2.6 Place the appliance back into position, level the appliance if
required by adjusting the 3 levelling screws and then secure
in place using the screws supplied (see Diagram 5).
5
AR1292
2.7 It will now be necessary to decide upon the flue route and
make the necessary flue connections. Two types of flue
termination are available, a horizontal terminal discharging
on a vertical wall or a vertical terminal discharging above
the roof level. Refer to Section 2 in Site Requirements for
allowable flue configurations in each instance.
15
INSTALLATION INSTRUCTIONS
INSTALLATION
2.8 When the flue configuration and lengths are known, it may
be necessary to fit a flue restrictor. Refer to Technical
Specification on page 10 for the correct restrictor size. This
should be fitted by removing the internal and external
spigots. The restrictor should be located between the
underside of the inner spigot and the air duct. Refer to
Diagram 6.
6
AR0627
2.9 Before any flue pipe is attached to the appliance, unwrap
the decorative cast iron collar and locate over the outer flue
spigot ensuring that the location lug locates in the notch at
the rear of the hole (see Diagram 7).
7
AR1293
2.10 When installing the horizontal terminal, decide on the
terminal position and measure the height from the top of
the appliance to the centre of the required hole. Refer to
Section 2 in Site Requirements for minimum and maximum
flue dimensions.
2.11 A 152mm (6") diameter hole is required to install the flue.
This can be achieved by either:
a) Core drill
b) Hammer and chisel
It is advisable to drill small holes around the circumference
when using method b. Make good both ends of the hole.
15

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gazco Riva Nemos Coprecci bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gazco Riva Nemos Coprecci in de taal/talen: Engels als bijlage per email.

De handleiding is 3.17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info