9
Additional safety instructions for
Submersible Water Pumps
WARNING! The water Pump together with associated pipework
operate under pressure. Do not disconnect water Pump or pipework
until internal pressure has been released. Failure to do this could
result in personal injury and damage to property.
• Avoid inserting hands into the inlets/outlets of the water Pump while
it is connected to power.
• Before using the water Pump, always inspect it visually. Do not use the
Pump if it is cracked and/or damaged. If the water Pump is damaged,
contact customer service.
• The water Pump has a built-in thermal protection overload switch.
The water Pump stops if an overload occurs. The motor restarts
automatically after it has cooled down.
• The Pump must not be used in situations where people are in
the water.
• Never work or perform maintenance on the Pump without rst
making sure it has been disconnected from the mains power.
• Pollution of the liquid could occur due to leakage of lubricants
Important: Avoid inserting hands into the mouth of the Pump if it is
connected to the mains.
• Do NOT put your hands or other body parts into the water when the
Pump is in operation and connected to 240V mains power. In a fault
condition, this could result in electrocution.
The electrical connection must always be made in a dry area.
Make sure that electrical connections are protected from inundations.
Protect the plug and the power cable from heat, oil or sharp edges.
If damaged, the power cable must be replaced by a qualified electrician,
manufacturer, its service agent or similarly qualified person in order to
avoid a hazard.
7
