724644
11
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
47.1cc Petrol Chainsaw
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. 61705 • 08/2018 • FCS4800A
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
47.1cc Petrol Chainsaw
MODEL: №. 61705 • 08/2018 • FCS4800A
18 19
5. Secure fuel tank cap (9) nger tight, and then using the oil tank cap (7),
secure the fuel tank cap (9). ENSURE you wipe any residue from around the
fuel tank cap (9).
6. It is important to now ll the combination oil tank (6) with 4 stroke engine
oil per following instructions.
NOTE: Should you lose the oil tank cap (7), an additional oil tank cap (7) has
been supplied with this chainsaw
Adding 4 Stroke Oil to the Chainsaw
WARNING: Always ensure the engine is turned o before
undertaking this task.
WARNING: Never start work unless the chain (20) and guide bar (19)
are lubricated.
NOTE TO CHECK: Always ensure the combination oil tank (6) is full of 4 stroke
engine oil each time the chainsaw is being used.
1. Using a funnel, ll the oil tank (6) with 260ml of quality 4 stroke oil, or to just
under the lip of the oil tank opening. (Fig S).
2. Fasten the combination oil tank cap (7), and if there is any spillages, ensure
you clean with a clean rag.
Preparation Operation
Operation
WARNING: Do not start the engine whilst the chainsaw hangs from one
hand. This is very dangerous as the chain (20) may come in contact with your
body and the starting action is not controlled .
NOTE: This chainsaw is tted with an easy start recoil starter (11).
This means the recoil starter only needs to be pulled at a steady medium rate
and not hard vigorous pulling.
1. Fill the fuel and oil tanks respectively per
previous instructions and ensure both caps are
secure. Remove the bar cover (31).
2. Press in the priming bulb (5) up to 10 times, or
until the priming bulb (5) is rm and full of fuel,
when the chainsaw is cold or being used for the
rst time, or after the chainsaw has previously
run out of fuel (Fig T).
4. Press the on/o switch (4) to the “On position, as marked with an “I (Fig
U). For safety when starting, make sure the front guard / chain brake (13) is
on by pushing it rmly towards the nose of the chainsaw bar until a click is
heard (Fig V).
5. When the machine is cold, or the chainsaw has previously run out of fuel,
pull out the choke control (10) to the fully extended position (Fig W).
6. Hold the chainsaw securely on the ground by
placing one foot on the rear handle, one hand
securing the front handle. Using your other
hand, pull at a steady and medium rate on the
recoil starter (11) (Fig X).
7. Repeat until the engine res, and then STOP as
soon as the engine kicks (attempts to start) or
runs in any way.
8. Push the choke control (10) back in (Fig Y).
9. Pull the recoil starter (11) again and restart the
engine. Allow the engine to warm up.
10. When ready to start cutting, release the front
guard / chain brake (13), by pulling it rmly
towards the back of the chainsaw until a click is
heard (Fig A).
U. V. W.
X.
Y.
FULLY
EXTEND
X 10
T.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gardenline FCS4800A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gardenline FCS4800A in de taal/talen: Engels als bijlage per email.

De handleiding is 1,94 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info