15
GB
Assembling the handle:
3. Assembly
1. Insert lower part of bottom upright
1
into upright holders
2
up to stop and
secure with the screws
3
.
2. Push connector
4
from underneath
into upper part of bottom upright
1
.
3. Insert threaded rod
6
from left through
lower parts of central upright
5
,
upper part of bottom upright
1
and
connector
4
right up to the stop.
4. Slide threaded bearing
8
into
clamping lever
7
.
5. Screw clamping lever
7
onto
threaded rod
6
approx. 4 turns.
6. Move clamping lever
7
onto
connector
4
and check whether
clamping lever
7
locks.
7. If clamping lever
7
does not yet
lock, screw another turn onto
threaded rod
6
. Repeat procedure
until clamping lever
7
locks on
connector
4
.
8. Push the screws
9
through the
upper handle
0
and the middle
handle sections
5
and secure with
the 2 wing nuts
A
.
The safety lock
B
of the handles
0
must be
on the right in the direction of travel.
9. Fix the motor cable
C
to the handle with the two cable
clips
D
.
4. Function
To produce a well-maintained lawn we recommend cutting the
lawn once a week if possible. The lawn becomes thicker if cut
frequently.
Relatively long cut grass (
>
1 cm) must be removed so that the
lawn does not become yellow and matted.
After relatively long intervals between mowing (holiday lawn), up
to max. 12 cm, first of all cut in one direction with the cutting height
as high as possible, then cut in the crosswise direction at the
cutting height required.
Storage:
The cylinder lawnmower and the Accu must not
be stored at more than 45 °C or when exposed
to direct sunlight.
Ideally, the Accu should be stored below
25 °C.
Mowing correctly:
7
8
7
9
4
5
B
0
6
C
D
9
D
1
A
6
7
7
4
1
2
3
