Mowing with the grass box:
L
F
M
N
6
19
GB
Adjusting the cutting height:
Mowing on a slope:
4
z
S
K
4
For safety reasons, on first use, the upper part of the hand-
le must be drawn out fully. It can then no longer be collap-
sed to the as-delivered position.
The clamping force can be adjusted via the nut
J
. If the
clamping effect decreases, open the clamping lever and
turn the knurled nut clockwise (e.g. with pliers).
The cutting height can be adjusted from 2.0 to 6.5 cm in 1.5 cm
stages (4 positions).
v Unscrew wheels
4
by hand and screw back in firmly at the
cutting height required.
All 4 wheels
4
must always be screwed in at the same cutting
height (see scale
z
S
on the back of the wheel mounting).
To prevent sliding sideways on a slope, the front
A wheels and the steering wheel must be locked in the
straight ahead position before using the mower on
the slope.
Do not use the mower on a slope steeper than 15° maximum.
1. Turn both red swivel wheel locks
K
by 90° (groove in direction
of travel).
2. Bring front wheels
4
into straight ahead position until the
lock
K
engages.
The wheels are now locked in the straight ahead position.
3. Lift steering wheel lock
L
upwards.
4. Bring steering wheel
F
into the straight ahead position until
the lock engages.
The steering wheel is now locked in the straight ahead position.
After mowing on the slope has been completed, the front wheels
and the steering wheel can be unlocked again by turning the
running wheel locks
K
by 90° and folding the steering wheel
lock
L
downwards.
When mowing on slopes, mow in lines across the slope.
The grass box must be emptied as soon as grass is left lying
on the lawn.
DANGER! Foreign bodies thrown out of the mower
A can cause injuries!
V Only lift protective flap with the motor switched
off and the cutting blade stationary.
TIP: If the handle is tilted to the side, it is easier to empty the
grass box.
1. Lift protective flap
M
and remove grass box
6
by the handle.
2. Empty the grass box
6
and hang it on the back again using the
mounting hook
N
on the casing.
