Adjusting the swivelling handle:
Error:
Error LED flashes Blockage protection
Error LED is Voltage too low
illuminated
Switching off the Mower:
Charge display:
green LED Accu fully charged
yellow LED Accu half charged
red LED Accu flat
18
GB
1. Place the Flexible Steerable Mower on a flat area of lawn.
2. Open key flap
A
.
3. Insert safety key
B
in the charging socket
C
.
4. Keep the start button
D
pressed and draw switch handle
E
towards the steering wheel
F
.
The mower will start and the charge level indicator
G
will be
illuminated for 10 seconds.
5. Release the start button
D
.
6. Guide the mower forwards at walking pace.
If the red LED ( Accu flat) flashes, the motor will switch off and
the Accu must be charged (see 7. Maintenance).
The Accu cover must always be kept closed during mowing. The
Accu becomes warm when using the Flexible Steerable Mower.
This is normal and does not impair its performance.
Blockage protection: If the cylinder mower is blocked by a
foreign body or the motor is overloaded (red Error-LED flashes),
the motor is automatically switched off by the blockage protection.
Remove Safety Key from socket, remove foreign body or rectify
the cause of the overloading and restart the mower after a few
seconds.
Discharge protection: The mower switches off automatically
as soon as the capacity of the Accu has been exhausted
(Error LED is illuminated = voltage too low). We recommend
recharging the battery straight away.
Note: The Flexible Steerable Mower is protected from being
switched on accidentally by removing the Safety Key.
1. Release switch handle
E
.
2. Remove safety key
B
each time work is interrupted.
1. Press both push-buttons
F
simultaneously and lift up the upper
part of the handle
H
.
2. Open clamping lever
I
.
3. Draw out upper part of handle
H
to the length required.
4. Close clamping lever
I
again.
J
H E
IF
B
ED
F
A
B
C
G
G
