Installing the Spindle
The numbers correspond to the diagram on the
opposite page. Spindle extensions (SV 401-090 /
SV 401-205) are available should the appliance be
installed in a worktop which is non-standard depth.
Loosen the nuts of the spindle cover and remove
cover.
1 Insert the spindle from behind into the fitting of
the control knob. Be careful that the broader pin
of the control knob fits the broader fitting of the
spindle.
2 The gas tap of the burner must be in the off
position (flat side to the top). Slide the spindle on
the gas tap.
3 Fix the spindle with the screws provided.
Turn the control knob to the off position. Connect
the appliance to the power supply, and check for
correct functioning. If the appliance switches off
there may be air in the gas supply line. Turn the
control knob to the off position and relight. This may
need to be repeated until the appliance ignites.
20
spindle cover
