25
Installation
The dishwasher must be connected correctly,
otherwise it will not function properly. The
specifications for the inlet and outlet as well as the
electrical connected loads must correspond with the
required criteria as specified in the following
paragraphs or in the installation instructions.
Install the appliance in the correct sequence:
1 Checking appliance on delivery
2 Installing the appliance
3 Waste water connection
4 Fresh water connection
5 Electrical connection
Safety instructions
Install and connect the appliance according to the
installation and assembly instructions.
Prior to installation, disconnect the dishwasher
from the power supply.
Ensure that the protective conductor system of
the domestic supply has been correctly installed.
The electrical connection conditions must
correspond with the specifications on the
dishwasher rating plate 9J.
If the power cord of this appliance is damaged, it
must be replaced with a particular power cord.
To prevent injury, the power cord may be replaced
by customer service only.
If the dishwasher is installed in a high-sided unit,
the unit must be secured properly.
Install built-under or integratable appliances only
under continuous worktops which have been
screwed to adjacent cupboards to ensure
stability.
Do not install the appliance near heat sources
(radiators, heat storage tanks, cookers or other
appliances which generate heat) and do not
install under a hob.
After installing the appliance, ensure that the plug
is easily accessible.
Some models:
The plastic housing on the water connection
contains an electric valve, the connecting cables
are in the supply hose. Do not cut through this
hose, do not immerse the plastic housing in water.
ã=Warning
If the appliance is not in a cavity and a side panel is
accessible, the door hinge area must be covered at
the side for reasons of safety (risk of injury). The
covers are available as optional accessories from
customer service or specialist outlets.
Delivery
Your dishwasher has been checked thoroughly in the
factory to ensure that it is in working order. This may
cause small water stains. These will disappear after
the first wash cycle.
Technical specifications
Weight:
max. 60 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2.0–2.4 kW
Fuse:
10/16 A
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure: connect pressure-
reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature 60 °C.