21
Spray arms
Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms 1: and
1Z.
1 Check outlet nozzles on the spray arms for
blockages.
2 Unscrew the upper spray arm 1:.
3 Remove the lower spray arm 1Z upwards.
4 Clean spray arms under running water.
5 Re-engage or screw on spray arms.
Troubleshooting
The majority of faults which could occur in daily
operation can be rectified by the user. This ensures
that the appliance is quickly available for use again.
The following overview will help you locating the
causes and gives helpful advise to eliminate them.
Note
If the appliance stops during dishwashing or does not
start for no obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled “Dishwashing”)
ã=Warning
If on the digital display 8 an error code (“:‹‚ to
“:„‹), always disconnect the appliance from the
power supply and then turn off the tap.
You can rectify certain faults yourself (see following
fault description), for all other faults please contact
customer service and state the indicated fault “:XX.
ã=Warning
Don’t forget: Repairs may be carried out by
technicians only. If a component has to be replaced,
ensure that only original spare parts are used.
Improper repairs or use of non-original spare parts
may cause considerable damage and put the user at
considerable risk.
