Originalbetriebsanleitung FUXTEC FX-EB152/FX-EB162_de_en_fr_ita_rev16
38
4. Instructions for accessories
● Make sure that your product is only equipped with original accessories. Only use
original parts that are specified by the manufacturer. The use of any other
attachments or accessories may cause injury to the user and damage to the
device.
● Clean the device thoroughly, especially the fuel tank and air filter. All fuel must be
removed after using the device.
● If you approach a user of the device as a spectator, carefully attract his attention
and confirm that the user will stop the device. Please do not startle or distract the
user. Otherwise, you could cause an unsafe situation.
● Never touch the drill when the device is running. If it is necessary to replace the
guard or drilling tool, be sure that the device and drilling tool has stopped.
● The device must be OFF before you change the working range of the device.
● If necessary, have the device repaired by an authorized dealer. If the device is
defective, do not let it continue to run.
● When starting or operating the device, never touch hot parts such as the
exhaust, ignition cables, or spark plug.
● After the engine has stopped, the exhaust is still hot. Never place the device near
inflammable materials (dry grass, flammable gases or flammable liquids, etc.)
● Pay particular attention to the fact that the ground can be slippery when
operating in the rain or immediately after the rain.
● If you slide or fall to the ground, release the throttle immediately.
● Take care not to drop the device or hit it against obstacles.
● Before adjusting or repairing the device, make sure that the device is stopped,
and the spark plug connector is disconnected.
● If the device is to be stored for an extended period, drain fuel from the fuel tank
and carburetor, clean the parts, place the device in a safe place and ensure that
the device has cooled down completely.
● Perform constant checks to ensure the safe and efficient operation of the device.
For a complete inspection, please contact a specialist workshop.
● Keep the device away from fire or sparks.
● Be careful when using it. There are dangers from kickback and recoil.
5. Notes on working with drilling tools
The device can be operated with different diameters of drills. Diameters from 60mm to
300mm can be used for this device. The use of drills other than those approved by the
manufacturer with this device is prohibited.
