522136
32
Verklein
Vergroot
Pagina terug
1/47
Pagina verder
25
4. INSTALLATION
4.1 Display Unit
Mounting considerations
The display unit can be installed on a
desktop, on the overhead or flush mounted
in a panel. When choosing a mounting
location keep the following in mind:
Keep the display unit out of direct
sunlight.
The temperature and humidity should be
moderate and stable.
Locate the unit away from exhaust pipes
and vents.
The mounting location should be well
ventilated.
Mount the unit where shock and vibration
are minimal.
Keep the unit away from electromagnetic
field-generating equipment such as
motors and generators.
For maintenance and checking purposes,
leave sufficient space at the sides and
rear of the unit and leave slack in cables.
A magnetic compass will be affected if
placed too close to the display unit.
Observe the following compass safe
distances to prevent disturbance to the
magnetic compass:
Standard compass: 0.5 meters
Steering compass: 0.35 meters
Desktop, overhead mounting
1. Fix the bracket to a desktop or the
overhead with tapping screws
(supplied).
2. Loosely screw knobs into the display
unit.
3. Set the display unit to the bracket and
then tighten the knobs.
Flush mounting in a panel
See the instructions on the flush mounting
template (supplied).
4.2 Thru-hull Mount
Transducer
Transducer mounting location
The thru-hull mount transducer (520-5PSD,
520-5MSD) provides the best performance
of all, since the transducer protrudes from
the hull and the effect of air bubbles and
turbulence near the hull skin is reduced.
When the boat has a keel, the transducer
should be at least 30 cm away from it.
Typical thru-hull mountings are shown in
the figure on the next page.
The performance of this sounder is directly
related to the mounting location of the
transducer, especially for high-speed
cruising. The installation should be planned
in advance, keeping the standard cable
length (8 m) and the following factors in
mind:
Air bubbles and turbulence caused by
movement of the boat seriously degrade
the sounding capability of the transducer.
The transducer should, therefore, be
located in a position where water flow is
the smoothest. Noise from the propellers
also adversely affects performance and
the transducer should not be mounted
nearby. The lifting strakes are notorious
for creating acoustic noise, and these
must be avoided by keeping the
transducer inboard of them.
The transducer must always remain
submerged, even when the boat is rolling,
pitching or up on a plane at high speed.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
32

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Furuno LS-6100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Furuno LS-6100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,21 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info