535711
8
Verklein
Vergroot
Pagina terug
1/78
Pagina verder
8
INTRODUCTION AND
OVERVIEW
MULTIPLE USERS
The system allows for up to 8 Users, a Master
(Admin) and 7 Users to be configured. This
allows the system Event Log to maintain a
record of which users have armed and disarmed
the system. Each user will have a different User
Access PIN Code.
Only the Admin User has access to the
programming functions and is able to configure
the system.
USER ACCESS PIN CODE
The Control Panel is the brains of the system
and is where the system is programmed and
operated from. A 4 digit PIN code is used to
ensure that only authorized people have access
to the system. This is the User access PIN code
and can be set to a code of your choice that only
you and other authorized system users know.
SYSTEM ARMING
The system has a ‘Fully Arm, two ‘Part-Arm
and a ‘Holiday Armmodes. Fully Arm and
Holiday Arm will ‘Arm’ all zones while the ‘Part-
Arm’ modes will only arm the zones that are
enabled for the particular Part-Arm mode.
For example:
The system could be configured so that during
night time, ‘Part-Arm-I’ would arm only zones
protecting the lower floor and outbuildings
leaving the upper floor free for movement
without triggering the alarm.
During the day while the property is occupied
‘Part-Arm-II’ could arm only the zones protecting
the outbuildings. However, when the property is
left un-occupied, the ‘Fully Arm’ mode will arm
all zones to protect the entire property, (i.e.
upper and lower floors and outbuildings).
ENTRY/EXIT DELAY
When the system is armed with the Exit-Delay
enabled, no signal from any detector on an
active zone will be able to trigger an alarm until
the Exit-Delay has expired. This enables the
system to be armed from within the property and
allows time for the user to exit the property
without triggering an alarm. If the Exit-Delay is
disabled then detectors on active zones will
immediately be able to trigger an alarm once the
system is armed.
Zones1&2 only have been pre-configured
with an entry/exit delay of 30 seconds
because detectors added on these zones are
Fully & Holiday Arm
Part-Arm-I
Part-Arm-II
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Friedland HISK1 GlobalGuard Alarm System bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Friedland HISK1 GlobalGuard Alarm System in de taal/talen: Engels als bijlage per email.

De handleiding is 2,92 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info