Ferm 07
Faulty and/or discarded electrical or electronic apparatus have to be collected
at the appropriate recycling locations.
Before using the appliance
• Make sure that the saw bench is adequately and effectively illuminated.
When you use strip lighting you should be aware of the so-called stroboscopic effect.
This may cause a rotating saw blade to appear to be stationary. One solution is to
use two fittings in order to create
phase displacement.
• Check the following points:
• Does the voltage of the motor and any fuse employed correspond with the mains
voltage? Appliances with a voltage of 230 V~ may be connected without
problems to a mains voltage of 220 V~.
• Are the feeder cable and plug in good condition: sturdy, without loose bits or
damage?
• Has the saw blade lost any teeth or is it displaying cracks or fractures? If so,
replace the saw blade immediately.
• The protective hood may not be set higher than required to let the workpiece
pass.
• The riving knife should be narrower than the saw cut and broader than the saw
blade.
• Do not exercise lateral pressure on the saw blade as it may cause it to break.
• Check the wood for knots, nails, cracks and waste residues.
These irregularities may cause the workpiece to kick back dangerously.
• Ensure that no objects get into the extraction system.
These objects may come into contact with the saw blades resulting in potentially
hazardous situations.
Using the appliance
• Push the workpiece that you are going to saw securely to the table surface.
Hold at the same time the section of the workpiece that has been sawed to prevent it
breaking off. The hand t hat secures the sawed section should remain behind the
saw blade and move away from it. Make sure that the hand that you use to secure
the workpiece does not cross the hand that you use to operate the appliance.
• Use the push stick supplied with the appliance.
Use the push stick to guide smaller workpieces past the saw blade.
• Do not use long extension cables.
• Allow the appliance to cool off before moving it.
• Do not remove wood residues in the vicinity of the saw by hand.
When wood residues are trapped between stationary and moving parts switch the
appliance off and remove the plug from the electrical socket. Only then remove the
residues.
• Select the appropriate saw blade.
Select the saw blade (with the correct teeth) and the correct speed of rotation and slip
appropriate for the material to be sawed and fit the saw blade carefully. This will not
only increase the lifetime of the saw blade but also prevent cracks and fissures with
their attendant hazards. Fit only recommended saw blades that meet European
standard EN847.
GB
82 Ferm
CE KONFORMITETSERKLÆRING (DK)
Vi erklærer herved, udelukkende på eget ansvar, at dette
FZB-205/800N
opfylder følgende standarder eller standardiserede dokumenter:
EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3, EN61029-1, EN61029-2-1
i henhold til bestemmelserne i direktiverne:
98/37/EC, 89/336/EEC, 2002/95/EC, 2002/96/Ec, 2006/95/EC
fr å 01-10-2007
ZWOLLE NL
J.A. Bakker - van Ingen J. Lodewijk
CEO Ferm BV Quality Manager Ferm Global
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor
til enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM • Zwolle Holland
DK
