40
1. Keep the ventilation slots of the machine clean in or-
der to prevent overheating of the motor.
2. In order to prevent damage to the motor and to make
an optimal use of an ideal cooling of the motor, chips
and dust must be removed regularly from it.
3. Do not use solvents to clean the plastic parts. Liquids
such as brake fluid, petrol, products on a paraffin base,
pickling oils etc. contain chemical substances which
can damage, corrode or destroy the plastic.
4. If the table inlay is worn out it must be replaced.
6. MALFUNCTIONS
In the case of the cutting-off machine not working pro-
perly, we give a number of possible causes and the ap-
propriate solutions below.
1. The electric motor becomes excessively hot.
The cool air slots of the motor are blocked with dirt.
- Clean the cool air slots.
The motor is faulty.
- Present the machine to your Ferm dealer for checking
and/or repair.
2. The machine does not work when switched
on.
The saw blade is jammed.
- Check the machine for objects which are causing it to
jam and remove them.
Interruption in the mains connection.
- Check the mains connection for breakage.
- Present the machine to your Ferm dealer for checking
and/or repair.
3. The motor stops during sawing.
The saw blade is jammed in the workpiece.
- Release the switch, remove the plug from the power
point and loosen the saw.
Interruption in the mains connection
- Check the mains connection for breakage.
- Present the machine to your Ferm dealer for checking
and/or repair.
4. The dust is not being vacuumed up.
This is possibly due to a blocked dust extraction.
- Clean the dust extractor opening.
CIEI➡
DECLARATION OF CONFORMITY
(
UK
)
We declare under our sole responsability that this
product is in conformity with the following
standards or standardized documents
EN61029-1, prEN61029-2-9, EN55014-1 + A1,
EN55014-2, EN61000-3-2, EN60555-3 + A1
in accordance with the regulations:
98/37/EEC
73/23EEC
89/336/EEC
from 26-05-1998
GENEMUIDEN NL
G.M. Ensing
Quality department
Ferm 5
