Ferm 67
GB
D
NL
F
E
P
I
S
FIN
N
DK
06 Ferm
Operation
Fig. B
Switching on:
Slide the switch to I, II or III.
I: 300 l/min 50° C constant (not adjustable)
II: 300 l/min 70° C - 600° C
III: 500 l/min 70° C - 600° C
On the steps II and III, the temperature at the nozzle outlet can the continuously regulated. After
displaying the target temperature, the actual temperature (e.g. 100° C) at the nozzle outlet is
shown with blinking until the selected target temperature is reached. The arrows
then disappear and the display shows the actual temperature.
The target temperature can be increased in steps of 10° C by pressing the “+” side of the
temperature button or reduced pressing the “-”. Brief pressing of the button increases or
decreases the target temperature one time by 10° C. When the temperature is excess 600° C,
the heats switches it off automatically, however, the heater continues to run. When the heater
has cooled to operating temperature, the heater is switched on again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all appliances on a little part of the workpiece.
4. MAINTENANCE
Always disconnect the apparatus before carrying out inspection or cleaning. Never
use water or other liquids to clean the electrical parts of the hot air gun.
• Never use easy inflammable liquids for cleaning the hot air gun, especially for the
mouthpiece.
• Regular maintenance of your hot air gun prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to prevent overheating.
Troubleshooting
In case the hot air gun does not work well, we give you subjoined some possible causes and
their solutions.
GB
D
NL
F
E
P
I
S
FIN
N
DK
