Ferm
Maskinerne er udviklet til at fungere længe uden problemer med et minimum af
vedligeholdelse. Ved at rengøre maskinen regelmæssigt og behandle den korrekt, bidrager
De til en længere levetid for maskinen.
Rengøring
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug. Sørg for at
ventilationshullerne er fri for støv og snavs. Brug en blød klud, der er vædet i sæbevand til
at fjerne hårdnakket snavs. Brug ingen opløsningsmidler, så som benzin, alkohol,
ammoniak, osv. Den slags stoffer beskadiger kunststofdelene.
Smøring
Maskinen behøver ingen ekstra smøring.
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er
så vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
NiMH celler kan genvindes.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres
på en genbrugsplads.
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
90
GB
D
NL
F
E
P
I
S
FIN
N
DK
Ferm 7
Electrical safety
Always check that the voltage on the batterypack corresponds to the voltage
on the rating plate. Also check that your mains voltage corresponds to the input
voltage of the battery charger.
The battery charger is double insulated in accordance with EN60335; therefore
no earth wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones.
It is dangerous to insert the plug of a loose cable in the wall outlet.
• Remove the battery block. When the power tool is not being used, prior to
maintenance and when changing tools such as the clamping chuck, and drill.
• The tool is suitable for use as a screwdriver and drill. Any other application is
specifically excluded.
3. MOUNTING ACCESSORIES
Prior to mounting an accessory always remove the battery.
Fitting and removing drill cutters
Fig. B
In addition to drill cutters, the tool can also accommodate screwdriver bits with a
hexagonal shaft.
• Loosen the drill chuck (4) by rotating the hand-grip (9).
• Insert the shaft of the drill cutter into the chuck.
• Tighten the drill chuck so that the drill cutter is firmly clamped.
• Rotate the drill chuck in the opposite direction when you wish to change the cutter.
Connecting and removing the battery
Fig. C
Ensure that the exterior of the battery block or tool is clean and dry before
connecting the charger.
• Ensure that the direction reversing switch (5 Fig. A) is in the central position in order to
prevent the appliance from being switched on unexpectedly.
• Insert the battery (5) into the base of the appliance, as shown on the illustration. Push
the battery until it latches in.
• Press the locking buttons (10) on both sides before removing the battery, and
disengage the battery from the base of the appliance.
GB
D
NL
F
E
P
I
S
FIN
N
DK
