34 Ferm
PRODUCT INFORMATION
Fig. A.
1. On/off switch
2. Support (Right)
3. Cover glass
4. Cover glass holder
5. Screw
6. Support (Left)
TECHNICAL SPECIFICATIONS
Voltage 230 V
Frequency 50 Hz
Power input 120 W
No load speed 2950/min.
Grinding stone dimensions 125 x 16 mm
Spindle hole 12,7 mm
Weight 5 kg
Lpa (sound pressure) 76 dB(A)
Electrical safety
Always check that the power supply corresponds to the
voltage on the rating plate.
Replacing cables or plugs
Immediately throw away old cables or plugs when they ha-
ve been replaced by new ones. It is dangerous to insert the
plug of a loose cable in the wall outlet.
Using extension cables
• The grinding machine is fitted with a three-core cable
and earthed plug. Therefore, always connect the plug
to an earthed socket. If you have to use an extension
cable, make sure it is three-core and fitted with an eart-
hed plug and connector.
• The minimum conductor size is 1.5 mm
2
.
INSTALLATION
Fig. B.
The holder of a cover glass, together with the co-
ver glasses themselves will always be adjus-
ted/mounted with the grinding stone being out of
action and the current turned out.
The grinding machine has to be secured to the bench by
means of bolts. The length of the bolts depends on the
thickness of the bench. If your bench is made of steel, it is
best to place the machine on a supporting, wooden plate
to separate it from the bench, to avoid vibrations.
MOUNTING AND ADJUSTMENT THE COVER GLAS-
SES AND HOLDERS
- Mount the holder of the cover glass together with the
cover glass itself, by means of the screw (A).
- Adjust the height of the holder of the cover glass by
loosening a bit screw . The free space between the sto-
ne and the holder of the cover glass will amount to 1 -
1,5 mm.
- Fasten well screw (A).
- Adjust the cover glass (see the figure above) in such a
way that your face will be protected, at the utmost.
- Use always safety glasses.
ADJUSTING THE TOOL REST.
Disconnect the machine and make sure the
grinding stone has stopped before adjusting the
tool rest.
Secure the tool rest, allowing a maximum clearance (C)
between the tool rest and the grinding stone of 1 -1.5 mm.
