42 Ferm
ANGLE GRINDER
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
CONTENTS:
1. Machine data
2. Safety instructions
3. Assembly
4. Use
5. Service & maintenance
1. MACHINE DATA
INTRODUCTION
This machine is developed for grinding and roughing of
metal and stone. With help of the correct accessories
the machine can also be used for brushing and sanding.
PACKAGE CONTENTS
1Angle grinder
1Side handle
1 Spanner
1Instruction manual
1Safety instructions
1Warranty card
TECHNICAL SPECIFICATION
FEATURES
Fig.1
1. ON/OFF-switch
2. Guard
3. Side handle
4. Grinding disc
5. Spindle lock
2. SAFETY INSTRUCTIONS
EXPLANATION OF SYMBOLS
In this manual and/or on the machine the following
symbols are used:
In accordance with essential applicable safety
standards of European directives
Class II machine – Double insulation – You don’t
need any earthed plug.
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
Indicates electrical shock hazard.
Risk of fire
Keep bystanders away
Remove the plug from the mains
Wear safety glasses and ear protection
Wear protective gloves
Read instructions carefully
Faulty and/or discarded electrical or electronic
apparatus have to be collected at the appropriate
recycling locations.
SAFETY INSTRUCTIONS
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions. Keep these
instructions in a safe place!
•Check that the maximum speed indicated on the
grinding disc corresponds to the maximum speed of
the machine. The speed of the machine must not
exceed the value on the grinding disc.
•Make sure that the dimensions of the grinding disc
correspond to the specifications of the machine.
•Make sure that the grinding disc has been mounted
and fastened properly. Do not use reducing rings or
adapters to make the grinding disc fit properly.
•Treat and store grinding discs in conformance with
the supplier’s instructions.
•Do not use the machine for grinding workpieces with
a maximum thickness exceeding the maximum
grinding depth of the grinding disc.
•Do not use grinding discs for deburring.
•When grinding discs have to be mounted on the
thread of the spindle, make sure that the spindle has
sufficient thread. Make sure that the spindle is
sufficiently protected and does not touch the
grinding surface.
•Before use, inspect the grinding disc for any damage.
Do not use grinding discs which are crack-ed, ripped
or otherwise damaged.
Voltage | 230 V~
Frequency | 50 Hz
Power input | 950 W
No-load speed | 11000/min
Disc diameter | 125 mm
Spindle dimension | M 14
Weight | 2,6 kg
Lpa (sound pressure) | 91,0 dB (A)
Lwa (sound power) | 104,0 dB (A)
Vibration value | 8,7 m/s2
Ferm 3
SPARE PARTS LIST FAG-125/950
FERM NR DESCRIPTION REF NR
406847 OUTER FLANGE 1
406846 INNER FLANGE 3
407008 PROTECTIVE GUARD 7
406951 SPINDLE GEAR 15
406952 AUXILIARY HANDLE 22
406953 PINION GEAR 24
407035 ROTOR 26
407036 STATOR 32
406954 CARBON BRUSH (SET) 35
406814 SPANNER 49
406955 SWITCH 51
406956 SWITCH SLIDE 52
406957 SWITCH BUTTON 54