wwwwww
..
ffeennddeerr..ccoomm
✧
wwwwww
..mmrrggeeaarrhheeaadd..nneett
10
MIDI
Adjusting Amp Settings
You can adjust any knob on the Cyber–Champ™ amplifier using the following
continuous controller numbers. Values range from 0=off to 127=maximum.
Continuous Parameter
Controller # Setting
07 Master Volume
85 Effects Off/On (0-63=off, 64-127=on)
102 Gain
103 Volume
104 Treble
105 Middle
106 Bass
107 Reserved
108 Master Volume
109 Reverb Level
110 Reverb Time
111 Reverb Dwell (Input)
112 Reverb Diffusion
113 Reverb Tone
114 Modulation Effect Level
115 Modulation Effect Rate
116 Modulation Effect Parameter 2 (see page 11)
117 Modulation Effect Parameter 3 (see page 11)
118 Modulation Effect Parameter 4 (see page 11)
119 Tap Interval
120 Delay Level
121 Delay Time
122 Delay Feedback
123 Delay Parameter 2 (see page 12)
124 Delay Parameter 3 (see page 12)
125 Reverb, Multi-Effects (see page 12)
126 Modulation Effect, Multi-Effects
127 Delay, Multi-Effects
Control changes can be recorded using
a sequencer so that you can play them
back during performances.
A sequencer must first capture knobs
before it can control their settings. To
do this, ramp the continuous controller
through the full range of values, then
return it to the desired value (setting).
The sequencer will then have active
control of the knob (parameter).
NOTE: If sequencer capture is lost (by
manually turning the knob for example)
the sequencer must recapture control
of that parameter to use it again.
See the MIDI Implementation Chart on
page 14 for details.
SPRING, ROOM, HALL, ARENA — Parameter value definitions
Level Amount of Reverb (0 is off, 127 is maximum)
Time Duration of Reverb sustain (0 is shortest, 127 is longest)
Dwell Signal level input to the Reverb circuit (versus output level controlled by the REVERB knob). (0 is minimum, 127 is maximum)
Diffusion Density of Reverb from sparse with non–uniform decay, to dense with smooth decay (0 is sparsest, 127 is smoothest)
Tone Brightness of Reverb (0 is darkest, 127 is brightest)
Advanced Effect Editing
Reverb
Reverb parameters in the figure and table below are accessible only by MIDI
continuous controller numbers 109-113 and have a value range of 0-127.
Reverb parameter
Continuous Controller
numbers
All 4 Reverb types have the same
5 editable parameters.
