22
Dehumidifying
Check that the water outlet hose is correctly connected, see page 16!
Press MODE until the DEHUM indicator lights up.
The temperature will be automatically set to 2 degrees below room temperature
(16°C to 31°C).
The fan speed will be automatically set to ‘LOW’.
Ventilation
Press MODE until the FAN light is lit
Press SPEED to select the desired air speed (low, medium or high).
When operating in the ‘cooling’ and ‘dehumidification’ modes, the device will
occasionally stop to allow the radiators to defrost. The device will start again after
several minutes. DO not use substances to accelerate this process and do not change
the settings!
If you set the apparatus to ‘cooling’ or ‘dehumidifying’, it will continuously operate
unless:
The room temperature becomes lower than the set temperature.
The timer is set to a final time.
Timer
The Timer button allows you to automatically start or stop the air conditioner at a
set time.
Automatic starting: Switch the device on and set the function (MODE) and
temperature. Now switch the device off again. Press the timer button and choose the
moment that you would like it to start working using the temperature buttons: each
time you press Λ (up) the hour will increase, each time you press V (down), the hour
will decrease. If, for example, the display shows 5 hours, the air conditioner will
switch on in 5 hours. Press the timer button again to confirm.
Automatic stopping: the air conditioner is on. Press the timer button and choose the
moment that you would like it to stop working using the temperature buttons: each
time you press Λ (up) the hour will increase, each time you press V (down), the hour
will decrease. If, for example, the display shows 2 hours, the air conditioner will
switch off in 2 hours. The timer can be set to between 1 to 24 hours.
Swing
Pressing the SWING button during operation will make the flaps (and thereby the air
stream) move up and down. Press again to stop the swing action.
Sleep
Select the ‘cooling’ MODE (COOL) and set the desired temperature.
Press the ‘SLEEP’ button – the device will automatically increase the desired
temperature by one degree after one hour, and by a second degree after a second
hour. The device will continue to operate at this setting.
Cancel the command by pressing ‘SLEEP’ again.