Operation
The control panel and remote control have the same buttons. This means that they
give the same commands. The control panel also has lights that indicate the mode
set. The control panel also has a W.F. light (water tank full) and a display that shows
the temperature and timer settings.
Before using the air conditioner, check:
That it has been installed according to safety instructions
That it is not damaged or broken
That the electrical socket that you wish to use has the same voltage as is given on
the unit’s specification plate (220-240V / 50Hz)
That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket. Start the unit by
pressing on the POWER button.
Use the MODE button to choose a specific function: automatic function, cooling,
dehumidifying or ventilate. Every time you press the button, the function changes.
The light on the control panel shows which function is active. If you are cooling or
dehumidifying, wait for up to 3 minutes after switching on or off before switching the
unit on or off again. The compressor needs this time to recover.
Automatic cooling
Press MODE until the AUTO indicator lights up.
The device will, depending on the ambient temperature, automatically select a
desired temperature with the accompanying function: cool, dehumidification or
ventilation. This indicator light will also activate.
