measured temperature to the calibrated room temperature. This can take up to 90
minutes. The Eurom Smart App shows the progress of the calibration process.
When the calibration is ready the display and the Eurom Smart App will show the
calibrated room temperature. When the calibration value is correctly measured the
calibrated room temperature will be approximately the same as the real room
temperature.
• When the heater stops heating, the calibration process will start in opposite direction
(cooling calibration). The device display will show CL and the Eurom Smart App will show
Calibration in progress. The cooling calibration process can take up to 150 minutes.
• Do not switch off the heater during the calibration process. Interrupting the calibration
process will cause a temporary difference between the calibrated room temperature
and the actual room temperature. In this case the heater will not heat up to the set
temperature. If by accident the calibration process is cancelled, the difference will
resolve itself over time.
For ceiling-mounted use it is recommended to use the Eurom Wi-Fi thermostat (365764 &
365771 (Swiss plug) or 365788 (USB-C version)) for optimal temperature control. The Wi-Fi
thermostat measures the room temperature and communicates the information via Wi-Fi to
the device.
After operation
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 16, pos. 2).
2. Disconnect the power plug from the power outlet (Figure 16).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control (Figure 17).
Maintenance
