ENDURO® LI1210 17 Ref: LI1210-UM-TKI-0821-Rev.A
Do not discharge the battery while the battery is charging.
Do not expose the battery/charger to harsh chemicals.
Keep the battery/charger away from children and animals.
Do not expose the battery/charger to flame or other high heat sources.
Charge battery regularly.
It is important to maintain at least 25% of your battery power when not in use.
Do not expose the battery/charger in a place with heat or with direct sunshine.
The chemical reaction during charging and discharging a LiFePO4 battery is not fully
reversible. Due to that, LiFePO4 batteries loose capacity during their life-span. This is
normal and not a manufacturing nor production fault.
FOR PROFESSIONAL INSTALLATION ONLY. These instructions are for
general guidance. Installation procedures may vary depending on your
situation
The LI1210 battery should not be used or installed by people, who don’t
have experience or knowledge how to use it. The user must have enough
competency to install it. Otherwise he must ask for help by qualified
personnel.
Unpack all the components and check for the presence of all parts (see package contents
list). Make sure the goods meet your requirement.
Check if the battery or charger isn’t damaged during the transport.
The charger and the battery should be put in indoor environment with good ventilation
and good cooling system. Do not expose to humid, high temperature, flammable,
explosive gas environments.
Find a suitable place for LI1210 battery and charger such as a storage area, under a seat
or a bed. Make sure there is sufficient ventilation all around. A space of at least 10cm
should be allowed.
Make sure that the battery and/or charger cannot be completely covered
by cloths or other isolation materials!
Mount the battery fixation bracket with the supplied screws
M3.5x18 on the bottom of the caravan. After mounting, the
battery “snaps” firmly into the bracket.
The plus (+) and minus (-) cables can be fixed to the output
terminals of the battery with the supplied M8 washers and bolts.
The output terminals of the battery must be covered by the
supplied isolation caps.
The plus (+) and minus (-) cables can also be connected via
quick clamps (not supplied) to the supplied DIN battery terminals.
