In the situation that the caravan battery is discharged too much to automatically draw back the corner steady,
or there is a defect, you can also do this manually.
Place the original 19mm socket manual handle on the 19mm hex-head of spindle (Fig. 5A), and turn it until the
corner steady is completely draw back.
The speed for manually draw back the spindle would not quicker than 1round per second.
Also do not reverse it very quickly during manually turning. Otherwise, the motor and
control unit maybe damaged by the sink current.
Repeat this also on all others corner steady.
As soon as the battery is charged again, or the problem is solved, the automatic spindle will work again.
To prevent the battery from becoming totally discharged during long periods of inactivity it must be
disconnected, fully charged and frost-proof stored.
Please check regularly that the spindle is free of any dirt, or debris that may have been picked up from the road.
Regularly grease spindle and corresponding screw nut. Dirt or corrosion of the autoSteady system spindles can
lead to premature shutdown!
Once a year have your autoSteady system maintained and visually inspected. This inspection must include all
the bolt/nut connections, the cables and electrical connections and lubrication of movable parts/joints.
In case of any failure or problem, please contact your ENDURO® autoSteady supplier.
Should your autoSteady system fail to operate, please check the following:
Unit fails to operate, does not function at all:
Make sure that the battery power isolation switch is turned on.
Check the cable-connection between the caravan battery and the control unit.
Check the fuse in the red positive battery cable (Fig. 13). If the fuse is blown, it must be replaced with a fuse of
the same value (20A). Never “bridge” the fuse (if needed contact your ENDURO® supplier). To replace the fuse,
first disconnect the positive (+) power cable from the battery. Than release the mounting screws that hold the
fuse (Fig. 13A), replace the fuse (Fig. 13B), and finally tighten the screws securely. Close the housing of the
fuse and connect the positive (+) power cable again to the battery. The system is ready again for use.
Check the battery of the remote handset. If empty, renew the 9V battery.
Caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any
further action.
Caravan battery could be overloaded. Check your charging equipment and try to discharge the battery by
connecting/using a light or any other load. If this does not give any result, renew caravan battery before taking
any further action.
Check the distance between the remote handset and the caravan is not more than 5 meters. If there is no
signal between the remote handset and the control unit, the autoSteady system will not function at all and the
green LED on remote handset will blink.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote handset and control unit. If there is no good communication between the
control unit and remote handset, the autoSteady system will not function and the green LED on remote
handset will blink.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the autoSteady system by switching off the autoSteady system via the isolation switch and the
remote handset for at least 15 seconds and then turn them on again.
